Cisco Systems ASR1000 manual Cisco ASR 1002 Router DC Power Supply, Minimum Maximum

Page 29

Chapter 2 Cisco ASR 1000 Series Routers Components

Cisco ASR 1000 Series Router Power Supplies

AC Power System Output Voltage Alarm Range for Cisco ASR 1002

The AC power supply output voltage alarm occurs when the output voltage is below the low end of the minimum or above the high end of the maximum limits shown inTable 2-18.

Table 2-18

Cisco ASR 1002 Router AC Power Supply Output Voltage Alarm Range

 

 

 

 

 

 

Minimum

Maximum

 

 

 

 

12 V

 

10.0 to 11.2V

12.8 to 13.8 V

 

 

 

 

3.3 V

 

2.6 to 3.0V

None

 

 

 

 

Cisco ASR 1002 Router DC Power Supply

This section provides information about the DC power supplies on the rear of the Cisco ASR 1002 Router. The recommended branch circuit breaker for the Cisco ASR 1002 Router DC power supply is 30Amp. Use an AWG #10 maximum wire gauge on the 30Amp circuit. The maximum branch circuit for the DC power supply module must not exceed 30Amp.

The Cisco ASR 1002 Router has two of the same type power supplies in power supply slot 0 and power supply slot 1. The power supply slot numbers are on the left side of the chassis and the power supplies are located on the floor of the chassis. The power supply switch is a Standby switch and is not considered a disconnect.

The DC input connector is a euro-style terminal block. The largest size gauge of wire that the front panel euro-terminal block can accept is AWG #10 wire. The terminal block is compliant to all safety agencies and electrical requirements of the power supply. Use the tie wraps to dress the input cable wires; there are two tie wrap tabs on the DC power supply.

The DC power supply unit is secured into the system chassis with two captive screws mounted on the faceplate.

Cisco ASR 1002 Router DC Power Supply LEDs and Connector

Figure 2-16shows the DC power supplies at the rear of the Cisco ASR 1002 Router. The Cisco

ASR 1002 Router supports up to two power supplies. The power supply LEDs and connectors on the rear of the chassis are described in the Table 2-19.

 

 

Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation and Initial Configuration Guide

 

 

 

 

 

 

OL-13208-01

 

 

2-29

 

 

 

 

 

Page 28 Page 30
Image 29
Page 28 Page 30
Contents A P T E R Cisco ASR 1000 Series Route ProcessorCisco ASR 1000 Series Route Processor 1 Features Carrier LED Link LEDColor -State Behavior Description LED LabelLabel Type Description Cisco Embedded ASR1000-RP1 for Cisco ASR 1002 Router Carrier Boot EUSB0 Flash3shows a fully-loaded Cisco ASR 1002 Router Cisco ASR 1000 Series Embedded Services ProcessorPage Stat Status Color Power Up State -Behavior DescriptionCisco ASR 1000 Series SPA Interface Processor Status LED PWR LEDColor-State Behavior Description Shared Port AdaptersCisco Embedded ASR1000-SIP10 Interface Subslot Numbering Cisco ASR 1000 Series Router Power Supplies AC and DC System Power Ratings AC and DC Power Supply TypesDescription Specification Power Supplies for Cisco ASR 1006 RouterAC Power Supply LEDs and Connector for Cisco ASR 10shows the AC power supplies LEDs and DB-25 alarm connector Input OK Color DescriptionOutput Fail DC Power Supply LEDs and Connectors for Cisco ASRFAN OK 910 Cisco ASR 1004 AC Power Supply Power Supplies for Cisco ASR 1004 RouterAC/DC Power System Output for Cisco ASR +12 VDC +3.312 Cisco ASR 1004 Router AC Power Supply Cisco ASR 1004 AC Power Supply LEDs and Connector13shows the AC power supplies LEDs and DB connector Cisco ASR 1004 Router DC Power Supply LEDs and Connector Cisco ASR Router 1004 DC Power Supply14 Cisco ASR 1004 Router DC Power Supply DC Power System Input for Cisco ASR Power Supplies for Cisco ASR 1002 Router Voltage Range VDC Minimum MaximumCisco ASR 1002 Router Power Supply Fans Cisco ASR 1002 Router AC Power SupplyCisco ASR 1002 AC Power Supply LEDs and Connector 15 Cisco ASR 1002 Router AC Power Supply AC Power System Output Voltage Alarm Range for Cisco ASR Cisco ASR 1002 Router DC Power SupplyCisco ASR 1002 Router DC Power Supply LEDs and Connector Minimum Maximum16 Cisco ASR 1002 Router DC Power Supply Minimum 10 a Maximum 39 a 125 a DC Power System Output for Cisco ASROL-13208-01
Related manuals
Manual 22 pages 55.04 Kb
Top Page Image Contents