Chapter 2 Cisco ASR 1000 Series Routers Components
Cisco ASR 1000 Series Embedded Services Processor
Table | Cisco Embedded | ||
|
|
|
|
Label |
| Type | Description |
|
|
|
|
CON |
| One | Console port used to connect to a terminal. |
|
|
|
|
AUX |
| One | Auxiliary port used for remote management |
|
|
| purposes. |
|
|
|
|
Figure 2-3 shows a fully-loaded Cisco ASR 1002 Router.
Figure 2-3 Cisco ASR 1002 Router Route Front View
4
3
ASR 1002 | |
stat | min |
pwr | maj |
| crit |
STAT
1
2
280283
1 | FO slot | 3 | The eUSB panel door on the side of the Cisco |
|
|
| ASR 1002 Router must not be opened. If there |
|
|
| is a problem with eUSB flash card, the chassis |
|
|
| should be returned. |
|
|
|
|
2 | R0 slot | 4 | Grounding stud |
|
|
|
|
The Cisco ASR 1000 Series Route Processor for the Cisco ASR 1002 Router deviates from the other route processor in the following ways:
•No SATA hard drive supported. Bulk file storage is on a large fixed EUSB device (up to 8GB supported).
•No support for redundant route processors.
•Network clock changes. No second BITS clock input supported.
•The connector and mechanical support for one half height SPA bay is included.
•The LED order is from top to bottom on the route processor is MIN, MAJ, CRIT.
Cisco ASR 1000 Series Embedded Services Processor
The Cisco ASR 1000 Series Embedded Services Processor (ESP) is based on the Cisco QuantumFlow Processor for
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation and Initial Configuration Guide
| ||
|