Cisco Systems ASR1000 manual Boot EUSB0 Flash, Carrier

Chapter 2 Cisco ASR 1000 Series Routers Components

Cisco ASR 1000 Series Route Processor 1

Table 2-3lists the Cisco embedded ASR1000-RP1 LEDs and behaviors.

Table 2-3	Cisco Embedded ASR1000-RP1 LEDs
LED Label	LED	Color —State	Behavior Description
PWR	Power	Green	All power requirements are within
			specification
STAT	System status	Green	Cisco IOS has successfully booted.
		Yellow	BootROM has successfully loaded.
		Red	System failure.
MIN	Minor	Amber	Minor alarm indicator.
MAJ	Major	Red	Major alarm indicator.
CRIT	Critical	Red	Critical alarm indicator.
BOOT	EUSB0 FLASH	Flashing Green	Active indicator.
	(BootDisk
		Off	No activity.
CARRIER		Off	Out of service or not configured.
		Green	In frame and working properly.
		Amber	Fault or loop condition.
LINK	10/100 /1000 RJ-45	Green	Link with no activity.
	Interface LED
		Flashing Green	Link with activity.
		Off	No link.
4 LEDs	Built-in SPA SFP	Off	Port is not enabled.
	port status
		Amber	Port enabled but there is a problem with the
			Ethernet link.
		Green	Port enabled, valid Ethernet link
PWR	SIP card power	Green	All SIP10 requirements are within specifi-
			cation.
STAT	SIP card status	Green	Only when the SPA drivers have started and
			are running and all critical processes are
			running
		Yellow	When ROMMON is running and during the
			download and boot of the operating system
		Red	A fault is detected or the card is powering
			up.

Table 2-4lists the Cisco embedded ASR1000-RP1 connectors and description.

	Table 2-4	Cisco Embedded ASR1000-RP1 Connectors
	Label		Type	Description
	BITS		RJ45 connector	Indicates BITS timing reference.
	MGMT		One RJ-45 jack for	The route processor has an ENET port with a RJ-45
			copper Ethernet	connector to attach a management device or network
			Management Ethernet	for network management.
			Port
	Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation and Initial Configuration Guide
OL-13208-01					2-7