Cisco Systems ASR1000 manual Label Type Description

Chapter 2 Cisco ASR 1000 Series Routers Components

Cisco ASR 1000 Series Route Processor 1

Table 2-1		Cisco ASR 1000 Series Route Processor 1 LEDs (continued)
No.	LED Label		LED	Color —State	Behavior Description
12	LINK		10/100/1000 RJ-45	Solid Green	Link with no activity.
			Interface LED
				Flashing Green	Link with activity.
				Off	No link.

* The type of alarm triggered is associated with the driver itself. For example, environmental alarms are tied to our environmental code, SONET alarms are tied to the sonet code, ENET to Ethernet.

Table 2-2lists the Cisco ASR 1000 Series RP1 connectors and description.

Table 2-2		Cisco ASR 1000 Series RP1 Connectors
No.	Label		Type	Description
1	ACO		Alarm cutoff switch.	When you press this button, an interrupt is
				generated informing software that the
				audible alarm relays will be disabled. This
				interrupt generates to both processors.
2	0		USB connector 0	Side-by-side USB connector used with
				memory sticks or smart cards for secure key
				distribution
3	1		USB connector 1	Side-by-side USB connector used with
				memory sticks or smart cards for secure key
				distribution
4	BITS		RJ45 connector	Indicates BITS timing reference.
5	MGMT		One RJ-45 jack for	The route processor has an ENET port with
	ETHERNET		copper Ethernet	a RJ-45 connector to attach a management
			Management Port	device or network for network management.
6	CON		One RJ-45 for CON	Console port used to connect to a terminal.
7	AUX		One RJ-45 for AUX	Auxiliary port used for remote management
				purposes.

The Cisco ASR 1000 Series RP1 meets the following requirements:

•Supports up to 4GB of ECC-protected memory with single-bit error correction and multi-bit error detection

•Supports On-board Failure Logging (OBFL) with 2MB of memory

•Supports the Cisco ASR 1000 Series Router system architecture, midplane, and the Cisco ASR 1006 Router

•Enhanced Serdes Interconnect (ESI) at 11.5 G bps.

•Gigibit Ethernet switches for EOBC communication and boot-up of the Cisco ASR 1000 Series SPA Interface (SIP) and Cisco ASR 1000 Series Embedded Services Processor.

•Runs Cisco IOS network control plane (routing protocol, connections setup)

•Cisco IOS punt packet forwarding

•Active/Standby Cisco ASR 1000 Series Route Processor 1 and Cisco ASR 1000 Series Embedded Services Processor selection

Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation and Initial Configuration Guide

OL-13208-01 2-5