D-Link D-Link Wireless ADSL Router, DSL-G624T manual Bridge Filters window

Page 65

DSL-G624T Wireless A DSL Router User’s Guide

Bridge Filters

Bridge filters are used to block or allow various types of packets through the WAN interface. This may be done for security or to improve network efficiency. The rules are configured for individual devices based on MAC address. Filter rules can be set up for source, destination or both. You can set up filter rules and disable the entire set of rules without loosing the rules that have been configured.

Enter the Advanced menu and click Bridge Filters button in the wizard column to open the Bridge Filters page.

Bridge Filters window

To add a bridge filter rule, check Enable Bridge Filters, type in a Source MAC, a Destination MAC or both in the entry fields, and click the Add button. To edit an existing rule, select the rule by clicking the Edit radio button. The rule will appear in the entry fields above as it is currently configured. Make the desired changes and click the Add button. To remove a bridge filter from the table in the bottom half of the window, click to select the corresponding Delete box, and then click Apply.

To save these configuration changes permanently, enter the System Commands page in Tools menu, click Save All button to save the configuration setting.

The protocols that may be specifically allowed or denied to pass through the WAN interface are the following: IPv4, IPv6, RARP, IPX-Ethernet, PPPoE Discovery and PPPoE Session.

57

Image 65
Contents DSL-G624T Page Table Of Contents Tools Setup Wizard Installation OverviewBefore You Start About This User’s GuidePacking List Installation RequirementsWAN Setting PasswordAdditional Software UsernameDSL-G624T LAN IP addresses forLAN Subnet Mask for Ethernet NICRouter Features 802.11g WirelessIntroduction Router Description and OperationDSL-G624T Wireless a DSL Router User’s Guide Standards Compatibility and Compliance Front Panel Display Rear Panel Connections Power insertWireless Security Wireless LAN BasicsRadio Transmission RangeAbout 802.11g Wireless Choosing the Best Location for Wireless Operation Hardware InstallationFactory Reset Button Power on RouterWired Network Connections Connect Adsl LineComputer to Router Connection Hub or Switch to Router ConnectionDSL-G624T Wireless a DSL Router User’s Guide Configuration Summary Basic Router ConfigurationConfigure Windows XP for Dhcp Configuring IP Settings on Your ComputerDSL-G624T Wireless a DSL Router User’s Guide Configure Windows 95 and Windows 98 for Dhcp Configure Windows 2000 for DhcpWindows Windows 95 and WindowsConfigure Windows NT 4.0 for Dhcp Configure Windows ME for DhcpWindows ME Windows NT 4.0 WorkstationsEnter Password Access the Configuration ManagerLogin to Home Web Manager First Time Log On Configure the RouterUsing the Setup Wizard Using the Setup Wizard Choose Time Zone Using the Setup Wizard Choose Connection Type Using the Setup Wizard For PPPoE/PPPoA connections Using the Setup Wizard For Dynamic IP Address connections Using the Setup Wizard For Static IP Address connections Using the Setup Wizard For Bridge Mode connections Using the Setup Wizard Finish and Restart Home Wireless LAN SetupWireless Settings menu Wireless Security Configure Basic Wireless SettingsConfigure WEP Wireless Security Security Options for WirelessWEP Encryption Setup Encryption KeysConfigure WPA Security for Wlan Configure WPA SettingsConfigure WPA-PSK Security for Wlan WAN Settings Menu PPPoE / PPPoA Configure WAN ConnectionPPPoE and PPPoA Connection for WAN PPPoE/PPPoA Parameters Description Default RouteUser Name FirewallDynamic IP Address Connection for WAN WAN Settings for Dynamic IP Address ConnectionCloned MAC Address Dynamic IP Parameters DescriptionBridged Connection for WAN WAN Settings Menu Bridge ModeStatic IP Address for Connection WAN WAN Settings Static IPIP Address Static IP Parameters DescriptionSubnet Mask Gateway AddressService Category ATM Settings for WAN connection PPPoE/PPPoA menuATM Traffic Shaping ATM QoS Parameters DescriptionATM VC Settings in WAN connection menu ATM VC SettingsATM VC Parameters Description Virtual CircuitConfigure LAN IP settings LAN IP SettingsUse the Router for Dhcp Dhcp Server Settings for the LANConfigure Dhcp Server settings for the LAN Disable the Dhcp Server Static IP Settings for the LANDhcp Settings menu with Dhcp disabled Static IP Assignment for LANConfigure DNS Settings DNS Server SettingsDynamic DNS Dynamic DNS ConfigurationSave and Reboot menu Save Settings and RebootAdvanced Router Management UPnP Enable UPnP MenuVirtual Server Menu and List Virtual ServerParameter Description Rule Management windowRule Name Private IPLAN Clients window LAN ClientsSnmp Management window SnmpSource IP Filters Configuration MenuFilters Source Port Destination IPDestination Port ActionBridge Filters window Bridge FiltersRouting Table RoutingDMZ DMZ IP address configurationFirewall Firewall Configuration MenuDynamic Routing RIP menu RIPPPP PPP Connection settings menuAdsl Adsl Modulation ConfigurationATM VCC ATM Virtual Circuit configuration menuQoS QoS Configuration screenConfigure Wireless Access Control Wireless ManagementConfigure Multiple Ssid Wireless ManagementWireless LAN Performance settings Wireless PerformanceTools System Tools administrative functionsRemote Web Management and Telnet Access Change System PasswordAdministrator Settings change password menu Remote Web And Telnet Access windowTime Time & Date ConfigurationRemote Log Remote Log Settings windowSystem Restore Factory Default SettingsSave System Settings and Restore Defaults Firmware Firmware UpgradePing Test Miscellaneous Miscellaneous Configuration menuTest Diagnostics Test MenuStatus Information Device Information display Device Information DisplayDhcp Clients window Dhcp ClientsView Log window LogTraffic Adsl Status information Technical Specifications Wireless Data Rates Wireless ModulationMedia Access Protocol Wireless CertificationUsing the Default IP Address IP Address SetupIP Setup Example #1 Assigning Network IP AddressesChanging the IP Address of the Router Using DhcpIP Setup Example #2 IP Addresses IP Concepts255.0.0.0 255.255.0.0 255.255.255.0 Subnet MaskMicro filters Micro filter InstallationMicro Filters and Splitters Split Line Filter

DSL-G624T, D-Link Wireless ADSL Router specifications

The D-Link Wireless ADSL Router, DSL-G624T, is a versatile and powerful networking solution designed for home and small office environments. This router combines the functionality of ADSL modem capabilities with the convenience of wireless connectivity, making it an ideal choice for users looking to establish a reliable internet connection without the hassle of multiple devices.

One of the primary features of the DSL-G624T is its ADSL2+ support, which allows download speeds of up to 24 Mbps. This high-speed capability ensures that users can surf the web, stream videos, and engage in online gaming with minimal lag and buffering. The built-in ADSL modem means that users can connect directly to their ISP with no need for additional hardware, simplifying setup and reducing clutter.

In terms of wireless technology, the DSL-G624T supports the 802.11g Wi-Fi standard, which offers a maximum theoretical speed of 54 Mbps. This allows for a stable and speedy wireless connection throughout the home or office, supporting multiple users and devices simultaneously. The router also features Wireless Distribution System (WDS) functionality, enabling users to extend the wireless network easily by connecting additional routers or access points.

Security is a crucial aspect of any networking device, and the DSL-G624T does not disappoint. It includes advanced security features such as WPA/WPA2 encryption, ensuring that users' data remains safe from unauthorized access. Additionally, the router supports MAC address filtering and firewall protection, providing an additional layer of defense against potential threats.

The DSL-G624T is equipped with four 10/100 Mbps Ethernet ports, allowing users to connect wired devices such as desktop computers, gaming consoles, or network-attached storage directly to the router. This is particularly useful for systems that require stable connections, such as for gaming or streaming high-definition content.

Installation and management of the DSL-G624T is user-friendly, thanks to its web-based interface. Users can easily configure settings, manage connected devices, and monitor their network's performance. The provision of DHCP support and easy-to-follow wizards streamlines the setup process for users of all technical levels.

In conclusion, the D-Link Wireless ADSL Router, DSL-G624T, combines high-speed ADSL modem capabilities with robust wireless networking features. With its solid performance, essential security measures, and ease of use, this router is a fantastic choice for users looking to enhance their internet connectivity at home or in small office environments.