Grizzly G0445, G9962Z Circuit Requirements, 220V/440V Connection, Extension Cords, Grounding

SECTION 2: CIRCUIT

REQUIREMENTS

220V/440V Connection

Hard wire this machine to a power panel that can safely supply power to your machine, that has the proper overload protection, and has a locking shut-off lever (Figure 6). If you are unsure about electrical wiring, consult a qualified electrician before attempting any wiring.

Figure 6. Locking Shut-Off Lever.

Extension Cords

Do not use an extension cord with 220V/440V machinery. An extension cord increases the risk of electrocution and fire. Instead, position your equipment near the power supply to eliminate the extension cord requirement.

Grounding

Electrocution or fire may result if machinery is incor- rectly grounded or the power supply violates local and state codes. Contact a qualified electrician for safe wiring practices!

G0445/G0582/G9962Z/9962ZX Wide Belt Sander

Amperage Loads

The following list outlines the electrical phase and voltage required to operate the various sander models, as well as the amperage draw of their motors. Note: If you do not have three-phase power available, you will have to install a phase converter such as the Grizzly Phase Converter.

Amperage Draw Specifications:

G9962Z—220V, Single-Phase ~60 Amp
10	HP Sanding Motor	............................ 50	Amps
1 HP Feed Motor		7	Amps
1⁄3 HP Table Motor		3	Amps
G9962ZX—220V, Three-Phase ~30 Amp
10	HP Sanding Motor	............................ 25	Amps
1 HP Feed Motor		3.4	Amps
1⁄4	HP Table Motor	1.2	Amps
G9962ZX—440V, Three-Phase ~15 Amp
10	HP Sanding Motor	......................... 12.5	Amps
1 HP Feed Motor		1.7	Amps
1⁄4	HP Table Motor	0.6 Amp
G0582—220V, Three-Phase ~30 Amp
10	HP Sanding Motor	............................ 25	Amps
1 HP Feed Motor		3.4	Amps
1⁄4	HP Table Motor	1.2	Amps
G0582—440V, Three-Phase ~15 Amp
10	HP Sanding Motor	......................... 12.5	Amps
1 HP Feed Motor		1.7	Amps
1⁄4	HP Table Motor	0.6 Amp
G0445—220V, Three-Phase ~30 Amp
10	HP Sanding Motor	............................ 25	Amps
1 HP Feed Motor		3.4	Amps
1⁄4	HP Table Motor	1.2	Amps
G0445—440V, Three-Phase ~15 Amp
10	HP Sanding Motor	......................... 12.5	Amps
1 HP Feed Motor		1.7	Amps
1⁄4	HP Table Motor	0.6 Amp
			-13-