SECTION 6: MAINTENANCE
General
Your safety is important! Please follow the warnings below during this entire section:
Disconnect power to the machine when perform- ing maintenance, assem- bly or adjustments. Failure to do this may result in serious person- al injury.
Loose hair and cloth-
ing could get caught in
machinery and cause seri-
ous personal injury. Keep
loose clothing and long
hair away from moving machinery.
Schedule
The following items should be checked each time the sander is used:
•Loose mounting bolts.
•Damaged sanding belt.
•Worn or damaged wires.
•Water collection cups filled with water.
•Dust trap.
•Safety features.
•Any other condition that could hamper the safe operation of this machine.
NOTICE
Keep in mind that the service intervals recommended below should occur sooner if the machine is operating under extreme duty or in a dirty shop enviornment.
Weekly
Grease the grease fittings located on the feed belt roller axles and the sanding belt roller axles. They are identified with yellow labels.
Monthly
Apply a generous amount of grease to the table elevation screws. Be sure to recover the adjust- ment screws with the dust covers when finished.
Remove the lower side panel to access the table lifting mechanism. Apply grease to the chain and gears associated with the table lifting mechanism. Be careful to not get grease on the
After the First 100 Hours
The oil inside the conveyor gear reducer should be replaced after the first 100 working hours of operation. We recommend 90 Wt. gear oil.
Every 2500 Hours
After the first conveyor gear reducer oil change, replace the oil after every 2500 working hours of operation. We recommend 90 Wt. gear oil.
G0445/G0582/G9962Z/9962ZX Wide Belt Sander |