Grizzly G0486/G0487 owner manual Beginning Assembly, Dust Collection, Air Line Installation

Beginning Assembly

Complete the assembly in the order provided in this manual. Then read the rest of the manual before attempting any type of sanding operation. Your safety is important! Please follow the warnings below during this entire section:

Disconnect power to the		Figure 12. Regulator knob.
machine for the assem-
bly process. Failure to
do this may result in		Dust Collection
serious personal injury.
Air Line Installation	An efficient and clean dust collection system is
	essential to the proper function of the sander.
	Ensuring a healthy work environment is also
To install the air line:	dependent upon cleaning and maintaining your
	dust collection system. 4000 CFM is recom-
1. Connect the hose from your air compressor	mended at the dust ports.
to the air inlet (Figure 11) on the regulator.	To hook up a dust collection system:
Regulator	1.	Install all ten dust ports (Figure 13) to the
Knob		mounting locations on the top of the sanding
		unit with the supplied M6-1 x 10 Phillips head
		screws.
Air ON/OFF
Lever
(Open Position)
Air Inlet
Figure 11. Air inlet located on regulator.

2.Make sure the is in the open inlet).

red handle on the regulator position (parallel with the air

3.	Lift the regulator knob (Figures 11 & 12)		Figure 13. A typical screw configuration.
	and turn it until the air pressure gauge reads
	75 PSI. Note: Turn the knob clockwise to	2.	Using 4" hose clamps, secure the hoses
	increase the air pressure and counterclock-
			from your dust collection system to the dust
	wise to lower the air pressure.
			ports.

4.Push the regulator knob down until it snaps.

-16- G0486/G0487 Wide Belt Sander