Grizzly G0574 installation instructions Manual Insert, Radiusing Sander

MANUAL INSERT

Model G0574

Radiusing Sander

INTRODUCTION

The Model G0574 Radiusing Sander is based on the Model G1140 Edge Sander with the addition of the radiusing attachment. Refer to the G1140 Edge Sander manual for the sanding unit assembly instructions and refer to the included G0577 Radiusing Attachment manual for radiusing attachment installation instructions. The Model G0574 DOES NOT include the work table, auxiliary table, and miter body listed in the manual of the G1140. These parts are unnecessary when the radiusing attachment is installed. The inventory for the G0574 is as follows:

Model G0574 Parts:

Figure 1. Model G0574.

•	Sanding Unit	1
•	Quick Release Lever	1
•	Dust Port	1
• 6'' X 80'' Sanding Belt		1
•	Back Stop	1
•	Feet	4
•	Long Support Bracket	1
•	Short Support Bracket	1
•	Guide Rail A	2
•	Guide Rail B	4
• Radius Control Swing Arm Assembly		1
•	Horizontal Adjustment Tubes	2
•	Locking Plate A	2
•	Locking Plate B	4
•	Brace	1
•	Height Adjustment Arms	2
•	Idler Roller Cover	1

Model G0574 Hardware Bag:
—Shim	1
—Hex Bolt 5⁄16"-18 x 2½"	3
—Hex Bolt 3⁄8"-16 x 1"	3
—Flat Washer 3⁄8"	11
—Flat Washer 5⁄16"	6
—Hex Nut 5⁄16"-18	3
—Hex Bolt 3⁄8"-16 x 2	2
—Hex Nut 3⁄8"-16	2
—7⁄32" Hex Wrench	1
—12-14mm Open End Wrench	1
—2mm Hex Wrench	1
—Phillips®Hd Screw 10-24 X 3/4''	4

NOTICE

When ordering parts for the Model G0574 Radiusing Sander, refer to the G1140 manual for sanding unit components, and refer to the G0577 manual for radiusing attachment components.

COPYRIGHT © MAY, 2005. BY GRIZZLY INDUSTRIAL, INC.

WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE

OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.

#EW7254 PRINTED IN TAIWAN