Grizzly G0574 installation instructions Beginning Assembly Feet

SECTION 4: ASSEMBLY

Beginning Assembly Feet

Assembly of the G1140 is straightforward. We have organized the assembly process into steps. Please follow them in sequence.

Tools Required: Only a few common tools are needed to assemble this machine. Specifically, a 6" adjustable wrench, 12mm open end wrench, regular and Phillips® screwdriver and an 8mm Allen® wrench.

All die-cut metal parts have a sharp edge (called “flashing”) on them after they are formed. This is generally removed at the factory. Sometimes a bit of flashing might escape inspection, and the sharp edge can cause cuts or lacerations when handled. Please examine the edges of all die-cut metal parts and file or sand the edge to remove the flashing before handling them. Serious injury may occur.

This machine is very heavy and can be awk- ward to handle without help. Get assistance during periods of assembly which require that the machine or any of its major compo- nents be moved, tilted, or carried. Failure to use proper lifting techniques could result in serious injury or damage to the machine.

1.Carefully lay the machine over on its side. Have someone assist you when doing this. Do not attempt to lay the machine over by yourself.

2.Install the four feet using the 10-24 x 3⁄4'' Phillips® Head Screws provided. Figure 3. Get assistance and upright the machine.

Figure 3. Installing the feet.

G1140 Edge Sander -9-