Miter Body | Quick Release Lever | |
|
|
|
|
|
|
Set the miter body onto its pivot hole and secure into place with the plastic lock knob provided. See Figure 12. The miter body should only be used when sanding the ends of workpieces at least 8'' long. Do not use it as a back stop.
Figure 12. Attaching the miter body.
Be certain that this machine is properly grounded before attempting to use it. If you are unsure of the quality and condition of the circuit you intend to use, have it inspect- ed and repaired by a qualified electrician. Failure to ensure proper grounding could result in fatal or serious injury and/or equip- ment damage.
Make your workshop
1.Loosen the belt tracking lock knob located at the top left of the machine.
2.Slide the quick release lever through the slot on the top of the platen cover. Thread it into place until it bottoms out. See Figure 13. It may be necessary to have an assistant push the idler roller back into the machine to allow the quick release lever to line up with the thread in the yoke.
Figure 13. Installing the quick release lever.
Operating this equipment has the potential to propel debris into the air which can cause eye injury. Always wear safety glass- es or goggles when operating equipment. Everyday glasses or reading glasses only have impact resistant lenses, they are not safety glasses. Be certain the safety glass- es you wear meet the appropriate stan- dards of the American National Standards Institute (ANSI).
G1140 Edge Sander |