Working Table
1.Bolt the lead screw bracket to the front of the stand using the four Hex Bolts already threaded in place. See Figure 4.
Figure 4. Lead screw bracket Installed.
2.Thread the horizontal brace into position, but do not tighten; the brace will require further adjustment later on. See Figure 5.
Figure 5. Installing the horizontal brace.
3.Locate the lead screw/table bracket assem- bly and the handwheel. Thread the hand- wheel onto the lead screw about halfway and insert the lead screw into the lead screw bracket. See Figure 6.
Figure 6. Installing the lead screw assembly.
4.Locate the vertical brace. Turn the horizontal brace approximately 45˚ and insert the verti- cal brace through the hole at the end of the horizontal brace. Rotate the horizontal / ver- tical brace assembly to 90˚.
5.Install the hex nut and washer provided, and screw on until 1⁄2'' of the threaded end is vis- ible above the washer. Insert the threaded end of the vertical brace through the hole in the bottom of the table bracket and re-install the flat washer and hex nut back onto the shaft. See Figure 7.
Figure 7. Horizontal / vertical brace installed.
G1140 Edge Sander |