Grizzly G0574 installation instructions Adjustments, Belt Tracking Auxiliary Table

Page 19

SECTION 5: ADJUSTMENTS

Belt Tracking

 

Auxiliary Table

 

 

 

 

 

 

1.Carefully move the belt left to right by hand and adjust the tracking knob as necessary to achieve proper tracking. See Figure 19.

2.Before beginning this step, read the entitled Test Run on page 18. Connect to power and turn the machine on and off quickly. If the belt appears to track OK turn the machine on and fine tune the tracking. Tighten the track- ing lock knob.

Figure 19. Location of tracking knob.

Moving sanding belts are dangerously abrasive. Use extreme caution when work- ing near sanding surfaces. Use extreme caution while making adjustments that require momentary or extended operation of the edge sander. Failure to exercise care while sanding could result in severe injury.

Loosen the thumb screws, position the auxiliary table, re-tighten the thumb screws. See Figure

20.Note that the ends of the roller are tapered. This helps keep the belt tracked. When using the end roller for curved sanding, we recommend you use the center portion of the roller to assure prop- er belt tracking. This also prevents the edge of the workpiece from becoming tapered.

Figure 20. Table adjustment thumbscrews.

 

 

 

 

 

 

 

 

 

 

 

 

G1140 Edge Sander

-15-

Image 19
Contents Manual Insert Radiusing SanderEdge Sander Page Table Of Contents Safety Instructions For Power Tools SafetyLength AMP Rating Additional Safety Instructions For Sanders Grounding Circuit Requirements220V/110V Operation Circuit LoadExtension Cords Wiring Diagram Commentary General InformationPiece Inventory UnpackingClean Up Site Considerations Beginning Assembly Feet AssemblyWorking Table Horizontal / vertical brace installed G1140 Edge SanderSee Figure Attaching the miter body Miter Body Quick Release LeverDust hood mounted in place Auxiliary Table Dust HoodBack stop properly installed Back Stop Belt InstallationBelt Tracking Auxiliary Table AdjustmentsTable Tilt Table Height Table height adjustment G1140 Edge SanderPlaten lock bolt Platen Tilt Belt TensionTest Run Edge & End Sanding OperationsTypical face sanding method Horizontal Sanding Contour SandingGeneralTable MaintenanceLubrication Closure Machine Data 220VOLT 44A 49A 46A Description Warranty and Returns Warranty Card Grizzly INDUSTRIAL, INC