Harbor Freight Tools 38123 operating instructions Figure F

Page 10

2.Set the Worktable (35) on its side, and align its mounting holes with the mounting holes in the Table Support (36). (See Figure F.)

3.Attach the Table Support (36) to the Worktable (35) using the Hex Screws (6), Lock Washers (7), and Flat Washers (8). (See Figure F.)

TABLE SUPPORT (36)

WORKTABLE (35)

FLAT WASHER (8)

LOCK WASHER (7)

HEX SCREW (6)

FIGURE F

4.Position the Table Support (36) in the corresponding mounting holes located on the side of the Base (42). (See Figure G, next page.)

5.Place a Flat Washer (8) on the shaft of the Knob (1). Then, screw the Knob into the threaded hole in the Base (42). (See Figure G.)

6.Loosen the three Hex Screws (6), and adjust the Worktable (35) so there is a maximum of 1/16” space between the Sandpaper Pad (27) and the Worktable. Then, retighten the Hex Screws. (See Figures F and G.)

SKU 38123

For technical questions, please call 1-800-444-3353.

Page 10

Image 10

Contents For technical questions and replacement parts, please call 38123Save this Manual SpecificationsGeneral Safety Rules Work AreaElectrical Safety Personal SafetySpecific Safety Rules ServiceTool USE and Care Industrial applications must follow Osha requirements Grounding Grounded Tools Tools with Three Prong PlugsDouble Insulated Tools Tools with TWO Prong Plugs Extension CordsSymbology See Figure CTo Mount The Table Assembly Assembly InstructionsTo Secure The Sander Base Assembly To a Workbench UnpackingFigure F Operating Instructions To Install The BackstopTo Adjust The Worktable For Vertical Sanding See Figure G SKU For technical questions, please callSee Figure To Level The Worktable AssemblySee Figure J To Install And Adjust The Sanding Belt See Figure KON/OFF Locking Switch Sanding Methods Surface Sanding On The Sanding BeltSanding Methods End Sanding On The Sanding Belt Sanding Methods Sanding Curved EdgesTroubleshooting Symptom Probable Cause RemedyTo replace the timing Drive Belt INSPECTION, MAINTENANCE, and CleaningDo not use damaged equipment See Figure Q, nextPlease Read the Following Carefully See Figure QParts List Assembly Drawing