Harbor Freight Tools 38123 Please Read the Following Carefully, See Figure Q

Page 18

F.Tighten the three Screws firmly. (See Figure Q.)

G.Grasp the Drive Belt (43) with two fingers on the outside-center and squeeze. There should be about 1/4” give to the Drive Belt for proper tension. (See Figure Q.)

H.Note: Too much tension on the Drive Belt (43) can load-down the Motor and cause possible damage. If the Drive Belt is too loose, it may fail prematurely.

(See Figure Q.)

I.Make sure to replace the Belt Cover (52). (See Figure Q.)

7.When storing: Store the Sander in a safe, clean, dry, location out of reach of children and other unauthorized people.

8.WARNING! All maintenance, service, or repairs not listed in this manual are only to be attempted by a qualified service technician.

DRIVE PULLEY (49)

 

 

DRIVE BELT (43)

 

 

DRIVE PULLEY (46)

 

 

LOOSEN

BELT COVER (52)

THREE SCREWS

FIGURE Q

PLEASE READ THE FOLLOWING CAREFULLY

THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY DIA- GRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR DISTRIBU- TOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABIL- ITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS

THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.

SKU 38123

For technical questions, please call 1-800-444-3353.

Page 18

Image 18
Contents For technical questions and replacement parts, please call 38123Save this Manual SpecificationsGeneral Safety Rules Work AreaElectrical Safety Personal SafetyService Specific Safety RulesTool USE and Care Industrial applications must follow Osha requirements Grounding Grounded Tools Tools with Three Prong PlugsDouble Insulated Tools Tools with TWO Prong Plugs Extension CordsSymbology See Figure CTo Mount The Table Assembly Assembly InstructionsTo Secure The Sander Base Assembly To a Workbench UnpackingFigure F Operating Instructions To Install The BackstopTo Adjust The Worktable For Vertical Sanding See Figure G SKU For technical questions, please callTo Level The Worktable Assembly See FigureSee Figure J To Install And Adjust The Sanding Belt See Figure KON/OFF Locking Switch Sanding Methods Surface Sanding On The Sanding BeltSanding Methods End Sanding On The Sanding Belt Sanding Methods Sanding Curved EdgesTroubleshooting Symptom Probable Cause RemedyTo replace the timing Drive Belt INSPECTION, MAINTENANCE, and CleaningDo not use damaged equipment See Figure Q, nextPlease Read the Following Carefully See Figure QParts List Assembly Drawing