INSPECTION, MAINTENANCE, AND CLEANING
1.
WARNING! 
Always turn the Sander’s ON/OFF Locking Switch (22) to its “OFF” position, remove the Switch Key (21), and unplug the machine from its electrical outlet and before performing any inspection, maintenance, or cleaning.
2.Before each use: Inspect the general condition of the Sander. Check for misalignment or binding of moving parts, loose, cracked or broken parts, damaged Power Cord, and any other condition that may affect its safe operation. If a problem occurs with the Sander, have the problem corrected before further use.
Do not use damaged equipment.
3.Before each use: Apply a light coat of paste wax (not included) to the Worktable (35) to make feeding stock easier.
4.After each use: Use compressed air to blow out dust and debris from Sander and its Motor.
5.After each 10 hours of use: Oil the Sleeve Bearings with 30 weight oil. To do so, release the belt tension by sliding the Tension Lever (66) to the right. Move the Sanding Belt (10) slightly to the right or left of the Idler Drum (65) to expose the
OIL HERE
SLEEVE BEARINGS
IDLER DRUM (65)
TENSION LEVER (66)
FIGURE P
6.To replace the timing Drive Belt:
A.Remove the Screw (44) from the Belt Cover (52). Then, remove the Belt Cover.
(See Figure Q, next page.)
B.Loosen the three Screws to allow the Drive Pulleys (46, 49) to shift enough to place the Drive Belt (43) around them. (See Figure Q.)
C.Place the Drive Belt (43) around the Drive Pulley (46), then around the other Drive Pulley (49). (See Figure Q.)
D.Tighten the three Screws slightly. (See Figure Q.)
E.Adjust the tension of the Drive Belt (43) by placing a Standard screwdriver in the adjusting hole and pushing up on the screwdriver to apply tension to the Drive Belt.
(See Figure Q.)
SKU 38123 | For technical questions, please call | Page 17 |