Sanyo XS1852 Wired Remote Control Unit Option, Installing the Wired Remote Control Unit

■Wired Remote Control Unit (Option)

(1)To access the printed circuit board, remove the cover plate of the electrical component box.

(2)Attach the remote control connectors securely to the mating connector pins on the printed circuit board.

(3)Turn the R.C.U. switch from “WIRELESS” to “WIRED”.

(4)Replace the cover plate.

Do not supply power to

the unit until the tubing and wiring to the outdoor unit is completed.

The mounting position for the remote control unit should be located in an accessible place for control and permit the average room temperature to be detected. Never cover the unit or recess it into the wall.

4-2. Installing the Wired Remote Control Unit

(1)Use a ballpoint pen or similar pointed object to remove the plastic bushing which is inserted in the rear of the remote control unit. The bushing can be discarded. (Fig. 4-4)

(2)Align the cord with the groove of the remote control unit.

(3)Attach the mounting plate to the wall with the 2 supplied screws. Then align the rail on the rear of the control unit with the slot of the mounting plate and slide the unit down as far as it will go. (Fig. 4-4) Fix the control unit cord to the wall.

(4)If local codes allow, the remote control unit cord can be wired in the wall. (Fig. 4-5)

Electrical component box

WIRED WIRELESS

R.C.U. Switch

Flat-head tapping screw 25/64"(3 ⋅ 10 mm) (SATA)

Cord clip

Remote control unit

Mounting plate

Truss-head tapping screw 5/8"(4 ⋅ 16 mm) (TOTA)

Cover plate

Connector for the wired remote control unit

1006_M_I

Fig. 4-3

Groove

Cord

Plastic

Rearbushing

Ballpoint pen

Remote control unit

Wall

1020_M_I 0531_M_I

Fig. 4-4 Fig. 4-5

16S4359128