Sanyo PNR-XS2432, XS1852 Finding the Address Switches Remote Control Unit

5. Address Switches

If you are installing one indoor unit or one group of indoor units in the same room, it is necessary for you to assign each unit its own address so that each can be operated by its own remote control unit. You assign the addresses by matching the switch position of each indoor unit with the switch position of its remote control unit. The switch of the remote control unit is shown in Fig. 5-1.

5-1. Finding the Address Switches

Remote Control Unit

Remove the lid by sliding it off. You can see the switches inside the battery compartment. (Fig. 5-1)

Indoor Unit

A B

Address

Address switch is in “A” position at time of shipment.

(1)	Turn off the Power Switch.	1008_M_I
(2)	Remove the Grille.
(3)	Remove the cover of the Electrical Component	Fig. 5-1
	Box.
5-2.	Switch Positions for 2 Units or 2 Groups of Units
Table 5-1 shows the positions you can use for up to 2

units or 2 groups of indoor units installed in the same room. Two remote control units are necessary to allow the respective units or group to be controlled indepen- dently.

Table 5-1
	Remote Control	Indoor Unit
Unit No.	Address switch	Address switch
		1	2
1	A	OFF	OFF
2	B	ON	ON
The indoor unit address switch is set at 1-OFF & 2-OFF
position at shipment.
NOTE
An indoor unit cannot be controlled if its remote control
unit is too far away (more than 26 ft.). If the remote
control unit does not work correctly, bring it closer to
the unit being operated and try again. There should be
				P.C.B
no obstacles between the remote control unit and the
indoor unit. For this reason, if the remote control unit is
to be used from a fixed position, check the operation
before mounting.

	ON
	1	2
WIRED	WIRELESS

R.C.U. Switch	Address Switch
	(DSW1)
	1321_M_I

Fig. 5-2

17S4359128