3-7. Installing the Ceiling Panel
(1)Lift the ceiling panel and position it to align the panel hook with the panel catch of the indoor unit.
(5)Install the air filter and
NOTE
The ceiling panel must be mounted in the correct direction. Note that the 2 catches of the panel differ in size.
Confirm that the catches are correctly matched be- tween the ceiling panel and the indoor unit body.
(2)Next, check to see that the ceiling panel is prop- erly aligned with the seamline of the ceiling. If it is not, remove the ceiling panel and slightly readjust the indoor unit body to the proper suspension point.
(3)When the ceiling panel has been properly aligned, use the supplied 4 mounting screws (M5) with washers to permanently fasten the ceiling panel.
(4)Install the wiring connector from the ceiling panel to the connector in the electrical component box of the indoor unit. After installing the connector, use the clamp on the body of the indoor unit to secure the wiring.
NOTE
Rehook the safety string before closing the
3-8. When Removing the Ceiling Panel for Servicing
When removing the ceiling panel for servicing, remove the
Panel catch (pull down)
Ceiling panel
Electrical component box
Clamp
Ceiling panel wiring connector
Connector on unit
(inside electrical component box)
Electrical component box Connector of ceiling panel
Unit body
Panel catch (pull down)
Ceiling panel
Screws M5 with washer
Mark
Air filter
| |
Fig. | 0967_X_I |
12S4359128