Schumacher SF 4022, SF 6030 Personal Precautions and Safety, Ground and AC Power Cord Connections

Page 2

B.PERSONAL PRECAUTIONS AND SAFETY

1.WARNING: Wear complete eye protection and clothing protection, when working with lead-acid batteries.

2.Make sure someone is within range of your voice or close enough to come to your aid when you work with or near a lead-acid battery.

3.Have plenty of fresh water and soap nearby for use if battery acid contacts skin, clothing, or eyes. If battery acid contacts skin or clothing, wash immediately with soap and water.

4.Avoid touching your eyes while working with a battery. Acid particles (corrosion) may get into your eyes! If acid enters your eye, immediately flood eye with running cold water for at least 10 minutes. Get medical attention immediately.

5.Remove all personal metal items such as rings, bracelets,

necklaces, and watches when working with a lead-acid battery. A lead-acid battery can produce a short-circuit current high enough to weld a ring (or the like) to metal, causing a severe burn.

6.Take care not to drop a metal tool or other metal onto the battery. Metal may cause sparking or short circuit the battery or another electrical devise. Sparking may cause an explosion.

7.Always operate battery charger in an open well ventilated area.

8.NEVER smoke or allow a spark or flame in the vicinity of the battery or engine. Batteries generate explosive gases!

C.GROUND AND AC POWER CORD CONNECTIONS

Charger should be grounded to reduce the risk of electric shock. Charger is equipped with an electric cord having an equipment grounding conductor and a grounding plug. The plug must be plugged into an outlet that is properly installed and grounded in accordance with all local codes and ordinances. This battery charger is designed for use on a nominal 120 volt circuit and has a grounded plug that looks like the plug illustrated in FIGURE 1

(A). This plug should be used in a grounded outlet. The plug pins must fit the receptacle (outlet).

ADAPTER: A temporary adapter, as shown in FIGURE 1 (B) and (C), may be used to connect the charger plug to a two pole re- ceptacle (outlet), as shown in FIGURE 1 (B).

NOTE: The temporary adapter should be used only until a prop- erly grounded outlet can be installed by a qualified electrician.

GROUNDING

SCREW

FIGURE 1 GROUNDING METHODS

DANGER: Never alter the AC cord or plug provided. If it will not fit outlet, have a proper outlet installed by a qualified electrician. Improper connection can result

in a risk of an electrical shock. DANGER: Before using an adapter, as illustrated, be certain that the center screw of the outlet plate is grounded. The green- colored rigid ear or lug extending from the adapter must be connected to a properly grounded outlet. Make certain it is grounded. If necessary, replace original outlet cover plate screw with a longer screw that will secure adapter ear or lug to outlet cover plate and make ground connection to grounded outlet.

 

"Use of adapter plug not allowed in Canada"

 

 

D.

PREPARING TO CHARGE

 

 

1.Make sure you have a 12 volt or a 6 volt lead-acid battery and select battery charger switch accordingly.

2.Clean battery terminals. Take care to keep corrosion from coming in contact with your eyes.

3.If required, add distilled water in each cell until battery acid reaches levels specified by battery manufacturer. This helps purge excessive gas from cells. Do not overfill. For a bat- tery without cell caps, carefully follow manufacturer's re- charging instructions.

4.Study all battery manufacturer's specific precautions, such as removing or not removing cell caps while charging, and recommended rates of charge.

5.Be sure area around battery is well ventilated while battery is being charged. Gas can be forcefully blown away by us- ing a piece of cardboard or other non-metallic material as a fan.

6.If necessary to remove battery from vehicle to charge, al- ways remove grounded terminal from battery first. Make sure all accessories in the vehicle are off, so as not to cause an arc.

7.A marine (boat) battery must be removed and charged on shore. To charge it on board requires equipment specially designed for marine use.

E.

CHARGER LOCATION PRECAUTIONS

Never place charger directly above the battery being charged, gases from battery could damage the charger.

Never allow battery acid to drip on the charger when reading specific gravity of filling battery.

Never operate charger in a closed in area, or restrict ventila- tion in any way.

Do not set battery on top of the charger.

553

2

Image 2
Contents Length of cord feet General Battery SafetyElectric Corporation AWG size of cordCharger Location Precautions Personal Precautions and SafetyGround and AC Power Cord Connections Negative Grounded Post Operating Instructions Charging Battery in VehicleOperating Instructions Charging Battery OUT of Vehicle Positive Grounded PostOutput Selector Controls AmmeterCharge Period Battery ChargingEngine Start Assembly Instructions Parts Tools necessaryTroubleshooting Problem Possible Cause SolutionElectric Corp Consignes DE Sécurité Générales SUR LES Chargeurs Consignes DE Sécurité ImportantesConservez CE Guide Longueur de la rallonge pieds 100 150 Calibre des filsRaccordement DU Cordon CA ET Mise À LA Terre Mise EN Garde SUR L’EMPLACEMENT DU ChargeurConsignes DE Sécurité À L’INTENTION DE L’USAGER Préparatifs DE ChargeBorne Négative Mise À LA Masse Borne Positive Mise À LA MasseCommandes DU Sélecteur DE Sortie MinutesCharge DE LA Batterie AIDE-DÉMARRAGEPériode DE Charge LE Chargeur Doit Être Assemblé Avant D’ÊTRE UtiliséInstructions D’ASSEMBLAGE 30 a 40 a 50 a 60 aProblème Cause Probable Solution DépannageConsignes DE Sécurité Importantes Conservez CE Guide