Schumacher 94080037, INC-812A, 00-99-000886/1208 operating instructions Preparing to Charge

Page 5

TO REDUCE THE RISK OF BATTERY EXPLOSION, FOLLOW THESE INSTRUCTIONS AND THOSE PUBLISHED BY THE BATTERY MANU- FACTURER AND THE MANUFACTURER OF ANY EQUIPMENT YOU INTEND TO USE IN THE VICINITY OF THE BATTERY. REVIEW THE CAUTIONARY MARKINGS ON THESE PRODUCTS AND ON THE ENGINE.

2.PERSONAL PRECAUTIONS

2.1Consider having someone close enough by to come to your aid when you work near a lead-acid battery.

2.2Have plenty of fresh water and soap nearby in case battery acid contacts your skin, clothing or eyes.

2.3Wear complete eye protection and clothing protection. Avoid touching your eyes while working near the battery.

2.4If battery acid contacts your skin or clothing, wash immediately with soap and water. If acid enters your eye, immediately flood the eye with cold run- ning water for at least 10 minutes and get medical attention immediately.

2.5NEVER smoke or allow a spark or flame in the vicinity of a battery or engine.

2.6Be extra cautious to reduce the risk of dropping a metal tool onto the bat- tery. It might spark or short-circuit the battery or other electrical part that may cause an explosion.

2.7Remove personal metal items such as rings, bracelets, necklaces and watches when working with a lead-acid battery. A lead-acid battery can produce a short-circuit current high enough to weld a ring or the like to metal, causing a severe burn.

2.8Use this charger for charging a LEAD-ACID battery only. It is not intended to supply power to a low voltage electrical system other than in a starter- motor application. Do not use this battery charger for charging dry-cell batteries that are commonly used with home appliances. These batteries may burst and cause injury to persons and damage to property.

2.9NEVER charge a frozen battery.

2.10NEVER overcharge a battery.

3.PREPARING TO CHARGE

3.1If it is necessary to remove the battery from the vehicle to charge it, al- ways remove the grounded terminal from the battery first. Make sure all of the accessories in the vehicle are off, so as not to cause an arc.

3.2Be sure the area around the battery is well ventilated while the battery is being charged.

2

Image 5
Contents Read Entire Manual Before Using this Product Page Table of Contents Important Safety Instructions Preparing to Charge Charger Location DC Connection PrecautionsBattery charging ac connections Grounding Methods Assembly instructionsDigital Display Button Battery Type ButtonControl panel Overview Operating instructionsGeneral Charging Notes Using the volt meter to test battery state of chargeDuration of the charging process depends on three factors Battery percent and charge timeStorage instructions Maintenance instructionsProblem Possible Cause Solution TroubleshootingLimited warranty Page LEA Todo EL Manual Antes DE Usar Este Producto Precaucion Page Table of Contents Instrucciones DE Seguridad Importantes PREPARación de la carga Precauciones PersonalesPrecauciones DE LA Conexión CC Ubicación DEL CargadorSiga Estos Pasos cuando la batería esté afuera del vehículo Bateria Cargando Conexiones AC Métodos a tierra 10.2 Botón de Battery TypeInstrucciones DE Ensamblaje Panel DE ControlPage Instrucciones DE Funcionamiento Aspectos Generales Notas Generales Relacionadas CON LA Carga La duración del proceso de carga depende de tres factores Porcentaje DE Batería Y Tiempo DE CargaInstrucciones DE Almacenaje Localización Y Solución DE ProblemasInstrucciones DE Mantenimiento Figuraciones