Milwaukee 6708-21, 6740-20, 6792-20, 6791-21, 6790-20, 6707-20, 6580-20, 6791-20, 6742-20 manual Operation

Installing and Removing Magnetic Sock- ets on Adjustable Screwdrivers

OPERATION

For Cat. Nos. 6580-20 & 6581-20 (Fig. 4)

1.Unplug tool.

2.To remove the magnetic socket, slide the locking sleeve forward and pull out the socket.

Fig. 4

Socket

Locking sleeve

3.To install the magnetic socket, slide the locking sleeve forward and push in the socket until it is fully seated.

For Cat. No. 6780-20 (Fig. 5)

1.Unplug tool.

2.To remove the magnetic socket, slide the locking sleeve forward and pull out the socket.

Fig. 5

Socket

Locking sleeve

3.To install the magnetic socket, simply push in the socket until it snaps into place.

WARNING

To reduce the risk of injury, wear safety goggles or glasses with side shields. Unplug the tool before changing accessories or making adjustments.

Using Forward/Reverse Switch (Fig. 6)

Fig. 6 Forward

Switch

Reverse Trigger

1.For forward (clockwise) rotation, push the forward/reverse switch to the left position as shown.

2.For reverse (counterclockwise) rotation, push the forward/reverse switch to the right position as shown.

Although an interlock prevents reversing the tool while the motor is running, allow it to come to a full stop before revers- ing.

WARNING

To reduce the risk of injury, keep hands and cord away from the bit and all moving parts.

Starting, Stopping and Controlling Speed

1.To start the tool, pull the trigger.

2.To stop the tool, release the trigger.

3.To vary the drilling speed, simply in- crease or decrease pressure on the trigger. The further the trigger is pulled, the greater the speed.

Locking Trigger (Fig. 7)

The lock button holds the trigger in the ON position for continuous full speed use.

1.To lock the trigger, hold the lock button in while pulling the trigger. Release the trigger.

2.To unlock the trigger, pull the trigger and release. The lock button will pop out.

Fig. 7

Lock button

Adjusting Locator Assembly (Fig. 8)

The locator assembly controls the tool's driving depth. These screwdrivers feature a locator assembly with one-handed depth adjustment. Depth adjustments can be made easily and quickly by turning the locator with one hand. Detents inside the sleeve “lock” the selected depth.

For the drywall ramp-off locator assembly, start with about 1/16" clearance between the head of the screw and nose with the snap- action clutch disengaged as shown.

For both locator assemblies, the detents on the inside of the sleeve represent different depths. Every two clicks of the locator equal 1/64". Continue adjusting the locator to the desired depth.

Fig. 8

Deeper

Locator

1/16"

1.To increase the driving depth, simply rotate the locator in the direction labeled .

8 9