Jet Tools HBVS-7MW manual Prior to Operation

Page 12

Prior to Operation

1.Check to see that the blade tooth direction matches the diagram on saw body.

2.Check to see that the blade is properly seated on the wheels after proper tension has been applied.

3.Set the blade guide roller bearings snug against

blade. See "Adjusting Blade Guide Bearings"for more detail.

4.Check for a slight clearance between the back up rollers and the back of the blade.

5.Position both blade guides as close to work as possible.

6.Select proper speed and feed rate for material being cut. See the enclosed "Lenox Guide to Bandsawing" for further information.

7.Material to be cut must be held securely in vise.

8.Check to see that coolant level is adequate.

9.Do not start a cut on a sharp edge.

1O. Keep the machine lubricated. See the "Lubrication" section.

Changing Blade Speed

1. Disconnect the machine from the power source.

2. Loosen the motor plate lock bolt (A, Fig. 7).

3. Loosen motor plate slide bolt (B, Fig. 7) until the belt can be moved on the the pulleys.

4. Move the belt to the the desired pulley combination.

5. Tighten the motor plate slide bolt (B, Fig. 7) to

re-tension belt.

Fig.7

6.Tighten the motor plate lock bolt (A).

7.Connect the machine to the power source.

6

Image 12
Contents JET Limited Warranty Replacement Part WarrantyLimited Tool and Equipment Warranty Proof of Purchase~ Warning AWG Minimum Gage for cordGro~nding Instructions Chart Make certain the machine is properly Table of Contents HVBS-7MWShipping Container Contents Unpacking and Clean-UpVertical Cutting Plate Assembly Electrical Connections Hydraulic Feed Selector OperationPrior to Operation Adjusting the Blade Guides Vise Adj ustmentAdjusting Blade Tension Changing Blades Disconnect the machine from the power source Adjusting Blade Square to Vise Adjusting Blade Tracking Adjusting Blade Guide Bearings Adjusting Automatic Shutoff Maintenance Chip Cleaning Brush~~~5~ 932-1504 Parts List For The HVBS-7MW Bandsaw Index Size QtyHigher HVBS7MW-89HVBS7MW-98 HVBS7MW-100HVBS7MW-152A HVBS7MW-GBElectrical Schematic