3.If adjustment is necessary, loosen the bolts holding the vice and adjust the vise so that the square lines up properly. Tighten bolts.
4.Connect machine to the power source.
Adjusting Blade Tracking
Note: Before making any tracking adjustments, try a new blade. Warped blades will not track.
Blade tracking has been set at the factory and should not require adjustment. If a tracking problems occurs, adjust the machine as follows:
1.Move the saw arm to the vertical position and lock in place by shutting off the hydraulic cylinder valve.
2.Confirm that blade tension is set properly. To
adjust, see section titled "Adjusting Blade Tension".
3.Open the back cover by loosening the lock screws.
4.Run the saw and observe the blade. Blade should run next to but not tightly against wheel flange.
5.Loosen bolts (A, Fig. 15).
6.Turn set screw (B, Fig. 15) while observing the blade tracking on the wheel. Turn the set screw clockwise to track the blade closer to the wheel
flange. Turn the set screw
B
7.Once tracking is set, tighten bolts (A, Fig. 15).
Fig.15
11