9.Turn the blade tension knob clockwise to tension the blade. Do not over tension. See section titled "Adjusting Blade Tension",
10.Close the blade cover door and secure with lock knobs.
11.Attach the red blade guard and brush assembly.
12.Connect the machine to the power source.
13.Run the saw and make sure blade is tracking properly.
For a discussion on blade selection, see the enclosed booklet entitled "Lenox Guide to
Bandsawing".
Adjusting Blade Square to Table |
1.Disconnect machine fromthe power source.
2.Place a machinist'ssquare on the table next to
the blade as pictured in Fig. 13.
3, Check to see that the blade makes contact with
square along the entire width of the blade.
4.If adjustment is necessary, loosen bolts (A, Fig. 13) and rotate the blade guide assemblies slightly in the same direction until the blade makes contact with the square along it'sentire width.
5.Tighten bolts (A, Fig. 13).
6.Connect the machine to the power source.
Note: If adjustment to square blade to table is necessary, be sure to check blade adjustments again.
Adjusting Blade Square to Vise
1.Disconnect the machine from the power source.
2.Place a machinist'ssquare as pictured in Figure 14. Square should lie along the entire length of vise and blade without a gap.
Fig.13
Fig.14
10