Shipping Container Contents

1Saw

2Wheel Axle

4 Wheel

4 Split Pin

1Material Stop Bar

1Material Stop

1Belt Cover

1Vertical Cutting Plate

Tools Required for Assembly

#2 Cross Point Screwdriver

Pliers

Unpacking and Clean-Up

1.Finish uncrating the saw. Inspect it for shipping damage. If any damage has occurred, contact your distributor.

2.Unbolt the saw from the skid and place it on a level surface.

3.Clean rust protected surfaces with kerosene, diesel oil, or a mild solvent. Do not use cellulose based solvents such as paint thinner or lacquer thinner. These will damage painted surfaces.

Assembly

Fig.1

1.Place blocking under the ends of the saw base to allow wheel installation. Caution: Make sure

saw is steady while temporarily supported.

2.Slide wheel axles through the holes in the base.

3.Slide the wheels onto the axles and fasten with pins. Bend the pins to hold in place.

4.Slide the material stop bar (A, Fig. 1) into the base and secure by tightening bolt (B, Fig. 1). Slide the material stop (C, Fig. 1) onto the bar and tighten bolt (D, Fig. 1).

5.Slide the belt cover over the pulley assemblies and fasten with screws and washers (A, Fig. 2).

Fig.2

6.Close belt cover and secure with lock knob (8, Fig. 2).