5.Place the saw arm in the horizontal position again. Wipe out remaining oil with a rag.
6.Fill the gear box with approximately 3/4 pint of 90 weight gear oil.
7.Replace the gasket and cover. Fasten the cover with screws.
8.Connect machine tTthe power ~ource.
Maintenance
1.Keep all surfaces clean and free of rust, slag, chips, and coolant
2.Do not use compressed air to clean the bandsaw. Compressed air may force chips into
the guide bearings and other critical areas of the saw.
3; Use a small paint brush or parts cleaning brush to remove metal particles.
4.Wipe the saw down with a clean, dry cloth and oil all unpainted surfaces with light machine oil.
5.Keep the blade guides clean and free of metal chips.
6.Checkthe guide bearings frequently to make sure they are properly adjusted and turning freely.
Chip Cleaning Brush
It is very important that the blade cleaning brush be properly adjusted and kept in good working order. Replace the brush if it becomes damaged or worn out. Blade life will be shortened severely if the brush is allowed to go out of adjustment, becomes damaged, or is worn out.
14