Jet Tools HBVS-7MW manual Adjusting the Blade Guides, Vise Adj ustment

Adjusting the Blade Guides

1.Disconnect the machine from the power source.

2.Loosen knob (A, Fig. 8) and bolt (B, Fig. 8). Slide te blade guide assemblies as close as possible to the the material without interfering with the cut.

3.Tighten knob (A, Fig. 8) and bolt (B, Fig. 8) and connect machine to the power source.

Vise Adj ustment

.!..) WARNING

To set the vise for 0 to 45 degree cutting:

1.Remove the bolt and nut assemblies (C, Fig. 9).

2.Position the vise and re-install as pictured in Fig.

10. Pay particular attention to the bolt hole location.

3.Set the vise to desired angle, re-install nuts and bolts, and tighten the nut and bolt assemblies.

4.Adjust the movable vise parallel to the fixed vise by loosening bolt (A, Fig.10), adjusting to parallel, and tightening bolt.

To set vise for maximum width of stock cutting:

1.Remove the nut and bolt assemblies.

2.Position the vise and re-install the bolt assemblies as pictured in Fig 9.

Fig.8

"-

Fig.9

Fig.10

7