Harbor Freight Tools 93808 Charging Battery, Installing & Removing the Battery Pack

Page 9

CHARGING BATTERY

NOTE: Refer to page 18, Figure 3 to help identify parts discussed below. Use the part numbers in the Parts List on page 21 and shown on the Assembly Diagram on page 22 to identify and order replacement parts.

NOTE: The Battery does not come charged from the factory. Charge before using. Charging room temperature: 50° F - 104° F.

1.Plug the Charger Base (O) into a wall socket. Note: The Charger Base (O) has both an ON red light, and an OFF green light.

2.When the Charger Base (O) is plugged into a wall socket, the RED light will come on and stay on steadily. This shows that all circuitry is working properly and the Charger Base is ready to charge.

3.Slide the Battery (H) forward until it firmly seats into the Charger Base (O). The GREEN light will go on and begin to flash. This indicates the battery is charging.

4.The charging period takes approximately one hour for a fully discharged battery and less for a battery not fully discharged. When the Battery (H) has been fully charged the Charger Base (O) will beep once and the GREEN light will stay on steadily.

5.Remove the Battery (H) from the Charger Base (O) and insert the Battery (H) into the base of the tool.

6.Press the test button on the Battery (H) to verify the battery is fully charged.

7.All four lights lit represent a full charge of the Battery.

FIGURE 1

FIGURE 2

Charger Base

INSTALLING & REMOVING THE BATTERY PACK

Warning! Do not touch the Trigger Switch (B) or the Trigger Release Button (A) while installing the Battery.

Insert the Battery (H) into the saw body as shown in Fig. 1. Fig. 2 shows the Battery (H) correctly inserted in the Charger Base (O).

SKU 93808 For technical questions, please call 1-800-444-3353.

Page 9

English

Image 9
Contents Cordless 18V Circular SAW With Laser General Safety Rules for ALL Battery Operatedtools Product SpecificationsSave this Manual Work AreaElectrical Safety Personal SafetyTool USE and Care Service Kickback Specific Safety RulesCauses and Operator Prevention of Kickback Symbology Battery Precautions Unpacking Never charge the Battery H more than two hours continuouslyInstalling & Removing the Battery Pack Charging BatteryWork Light and Laser Guide Installing Cutting Blade Adjusting the SAW Prior to CuttingOperation Functions Cutting Prepare Material Before CuttingPlease Read the Following Carefully INSPECTION, MAINTENANCE, and CleaningPart Description Qty Parts ListAssembly Diagram Prévenir LA Blessure Sérieuse Sans Cordon 18V LE Scier Circulaire Avec LE LaserSpécifications DE Produit Sauvez CE ManuelConservez CES Instructions Sécuritéélectrique Réparation Règles de Sécurité Particulières Causes du retour d’outil et prévention par l’utilisateur Modèle SymbologyPrécautions DE Batterie Défaisant Le fait de Charger la Batterie LE Fait D’INSTALLER LA Lame Coupante OpérationTravaillez LE Guide Clair ET À Laser LE Réglage DU Scier Avant LA Coupure Installation de Clôture d’Accroc et ajustageChiffre Coupure Préparez LA Matière Avant LA CoupureLisez S’IL Vous Plaît LE Suivant Soigneusement ’INSPECTION, LA Maintenance ET LE NettoyagePart Description Qty Liste DE PartiesDiagramme D’ASSEMBLAGE