WARRANTY
Every MILWAUKEE product is warranted to be free from defects in material and workmanship. MILWAUKEE will repair or replace any product which examination proves to be defective in material or workmanship.
Limitations: This warranty does not cover: 1) repairs made or at- tempted by other than MILWAUKEE or MILWAUKEE Authorized Service Station personnel; 2) normal wear and tear; 3) abuse; 4) misuse;
5)improper maintenance; 6) continued use after partial failure; 7) tools that have been modified; or product used with an improper accessory.
Battery Packs are warranted for one (1) year from the date of purchase.
Should a problem develop, return the complete product to any MILWAUKEE Factory Service Center or MILWAUKEE Authorized Ser- vice Station, freight prepaid and insured. If inspection shows the prob- lem is caused by a defect in material or workmanship, all repairs or a replacement will be made at no charge and the product will be returned, transportation prepaid. No other warranty, written or verbal, is authorized.
THE REPAIR AND REPLACEMENT REMEDIES DESCRIBED HEREIN ARE EXCLUSIVE. IN NO EVENT SHALL MILWAUKEE BE LIABLE FOR ANY INCIDENTAL, SPECIAL, OR CONSEQUENTIAL DAMAGES, INCLUDING LOSS OF PROFITS.
THISWARRANTYIS IN LIEU OFALLOTHER WARRANTIES, EXPRESSED OR IMPLIEDWHETHERFORMERCHANTABILITYORFITNESSFORPARTICULAR USEORPURPOSE.
This warranty gives you specific legal rights. You may also have other rights that vary from state to state. In those states that do not allow the exclusion of implied warranties or limitations of inciden- tal or consequential damages, the above limitations or exclusions may not apply to you.
page 8
ACCESSORIES
WARNING!
To reduce the risk of injury, always unplug the tool before attaching or removing accessories. Use only specifically recommended accesso- ries. Others may be hazardous.
For a complete listing of accessories refer to your MILWAUKEE Electric Tool catalog. To obtain a catalog, contact your local distributor or a service center listed on the back cover of this operator’s manual.
8'
Cat. No.
25'
Cat. No.
Offset Blade Adapter
Select Models (Fig. 7)
Cat. No.
An offset blade adapter is available to make flush cuts possible. To attach, remove blade clamping screw and blade clamp. Place adapter over spindle, lining up hole in adapter casting with threaded hole in spindle. Replace screw, attaching adapter to spindle. Blade can then be secured in adapter blade clamp in the same manner it was secured in the spindle clamp.
Fig. 7
Select Models:
Blade Clamp
Cat. No.
Blade Clamp Screw
Cat. No.
“787” Blades:
Blade Clamp
Cat. No.
Blade Clamp Screw
Cat. No.