Locking the Trigger
Always lock the trigger or remove the battery pack before changing accessories, making adjustments, or performing maintenance. Lock the trigger when the tool is not in use and when storing the tool.
1.To lock the trigger, push the trigger lock switch in the direction shown. The trig- ger will not work when the switch is in the locked position.
2.To unlock the trigger, push the trigger lock switch in the direction shown.
Fig. 6
Fig. 7 |
|
Straight | Orbital |
action | action |
Plunge Cutting
Your MILWAUKEE Sawzall® is ideal for plunge cutting directly into surfaces that can not be cut from an edge, such as walls or floors. Plunge cutting may be done two ways depending on how the blade is inserted. Column A shows how to plunge cut with the teeth of the blade facing down. Column B shows how to plunge cut with the teeth of the blade facing up.
NOTE: If the blade is installed with the teeth facing upward and orbital action is selected, cutting performance is reduced.
Do not plunge cut into metal surfaces (see “Cutting Metals”).
WARNING
To reduce the risk of explosion, electric shock and property dam- age, always check the work area for hidden gas pipes, electrical wires or water pipes when making blind or plunge cuts.
LockedUnlocked
Using the Orbit Control Switch
The Sawzall HatchetTM orbit control switch allows the tool to be operated in straight reciprocating (non orbital) or orbital action. Straight reciprocating action should be used when a smooth cut is needed. Orbital action is recommended for fast, aggressive cutting. The type of reciprocating action should be determined by the user for their specific cutting requirements.
1.For straight reciprocating action, press in the orbit control switch and slide the switch so the straight action symbol 
is shown.
2.For orbital action, press in the orbit control switch and slide the switch so the
orbital action symbol 
is shown.
Orbit action may be adjusted when the tool is running.
NOTE: If the blade is installed with the teeth facing upward and orbital action is selected, cutting performance is re- duced.
General Cutting
For straight or contour cutting from an edge, line the blade up with your cutting line. Be- fore the blade contacts the workpiece, grasp the handle firmly and pull the trigger. Then guide the tool along your cutting line. Always hold the shoe flat against the workpiece to avoid excessive vibration.
Cutting Metals
Fig. 8
AB
Begin cutting at a slow speed, gradually in- creasing speed as you cut. When cutting into metals or hard materials that can not be cut from an edge, drill a starting hole larger than the widest part of the blade. Extend blade life by using a solid blade cutting lubricant such as MILWAUKEE Band Saw Blade Lubricant Cat. No.
1.Insert the blade into the tool.
If you inserted the blade with the teeth facing downward, hold the tool as shown in Column A, resting the edge of the shoe on the workpiece.
If you inserted the blade with the teeth facing upward, hold the tool as shown in Column B, resting the edge of the shoe on the workpiece as shown.
2.With the blade just above the workpiece, pull the trigger. Using the edge of the shoe as a pivot, lower the blade into the workpiece as shown.
3.As the blade starts cutting, raise the handle of the tool slowly until the shoe rests firmly on the workpiece. Then guide the tool along your cutting line to acquire the desired cut.
NOTE: To make plunge cutting easier, use a heavy gauge blade.
8 | 9 |