Powermatic PWBS-14CS operating instructions Unpacking, Contents of the Shipping Container

Unpacking

The band saw is shipped in two cartons. Open both cartons and inspect contents for shipping damage. Report any damage immediately to your distributor and shipping agent. Do not discard any shipping material until the Band Saw is assembled and running properly.

Compare the contents of both cartons and all internal boxes with the following parts list to make sure all parts are intact.(*) Missing parts, if any, should be reported to your distributor. Read this instruction manual thoroughly for assembly, maintenance and safety instructions.

Contents of the Shipping Container

Carton #1 – Band Saw:

Refer to Figure 9.

1Band Saw – (A)

1guide rail – (B)

1rip fence – (C)

1rear rail – (D)

1front rail – (E)

1trunnion support – (F)

1level board – (G)

1miter gauge – (H)

1main table – (J)

1extension table – (K)

1drive belt – (L)

1quick tension lever – (M)

1owner's manual (not shown)

1warranty card (not shown)

2Hardware packages, as follows.

Hardware Package #1 contains:

Refer to Figure 10.

1support plate (HP1-A)

1air jet nozzle (HP1-B)

1cord clamp (HP1-C)

1pan head screw, M5x12 (HP1-D)

2table locking knobs (HP1-E)

6lock washers, M8 (HP1-F)

8flat washers, M8 (HP1-G)

5hex nuts, M8 (HP1-H)

6hex cap screws, M8x40 (HP1-J)

1hex cap screw, M8x80 (HP1-K)

Hardware package #2 contains:

Refer to Figure 11.

3hex (Allen) wrenches, 3,4,5mm (HP2-A)

4spacers (HP2-B)

4 hex nuts, M8 (HP2-C)

4 socket set screws, M8x20 (HP2-D)

4socket head cap screws, M6x25 (HP2-E)

4lock washers, M6 (HP2-F)

4flat washers, M6 (HP2-G)

4socket head cap screws, M8x65 (HP2-H)

2L-spacers (HP2-J)

10

Figure 9

Band Saw carton

Figure 10

Hardware package #1

(stock no. PWBS14-HP1)

Figure 11

Hardware package #2

(stock no. PWBS14-HP2)