4.Shift either end of the fence as needed to gain identical distance from table top.
5.Tighten both screws in the rear rail using a 10mm wrench.
Installing Front Rail and Rip Fence
Refer to Figures 26 through 29.
1.Install front rail (E, Figure 26) to the main table using two M6x20 hex cap screws
2.Install guide rail (B, Figure 27) to the slots in the front rail using three M6x20 hex cap screws
3.Attach the fence (C, Figure 28) to the fence body (P) with four 5/16”x3/4” hex cap screws
4.At the rear of the fence, thread a 1/4” hex nut
5.Hook the fence assembly over the rear rail, and onto the guide rail, as shown in Figure 28.
6.When the fence assembly is placed on the table, the rear hook
Setting Fence-to-Table Gap
The gap between the bottom of the rip fence and the table top should be high enough that the fence will not scrape along the table, yet low enough that thin workpieces won’t slip beneath it. The gap should be equal along the length of the fence. Adjust as follows:
Refer to Figures 29 and 30.
1.Lock the fence assembly to the front rail by pushing the fence handle down. The front rail screws should still have “play” in them.
2.Lift up on both guide rail and fence together until the fence/table gap at the front edge of the table is acceptable.
Figure 26
Figure 27
Figure 28
Figure 29
16