Installing Quick Tension Lever

Refer to Figure 36.

Install the quick tension lever (M) onto the shaft as shown, and tighten the two set screws using a 3mm hex wrench. The movement of the blade tension lever is explained under “Installing Blades”.

Stand Attachments

Refer to Figure 37.

1.Mount the two miter gauge hooks (HP3-B) to the side of the stand with two M8x16 carriage bolts (HP3-E) and two M8 flanged hex nuts (HP3-F). Position the hooks at an angle, similar to that shown in Figure 38. The miter gauge can be stored in these hooks.

2.Mount the blade hook (HP3-C)with two M4x10 pan head screws (HP3-H)as shown. The blade hook can store a rolled-up spare blade.

3.Mount the two fence hooks (HP3-A)to the opposite side of the stand with two M8x16 carriage bolts (HP3-E)and two M8 flanged hex nuts (HP3-F). The rip fence can be stored in these hooks when not in use.

Dust Collection

Refer to Figure 38.

The use of a dust collection system (not provided) is strongly advised when using the band saw. It will help keep your shop clean, and reduce the risk of health problems due to wood dust inhalation. The dust collector should have sufficient capacity for this size band saw (minimum 350 cubic feet per minute).

Connect a 4” diameter dust collection hose (not provided) to the port at the back of the band saw, and secure tightly with a hose clamp, as shown.

Note: Dryer vent hose is not suitable for dust collection purposes.

Riser Block Accessory

A Riser Block kit (stock no. 1791217, not provided) is available as an accessory. When installed, it increases resaw capacity (workpiece height capacity) to 12 inches. If you have purchased the Riser Block, consult the instruction sheet that accompanies it.

Figure 36

Figure 37

Figure 38