Installing Trunnion Support

Refer to Figure 21.

1.Use the two locating pins attached to the saw body to help position the trunnion support. Attach trunnion support to saw body with two M8x30 hex cap screws (HP1-

J)and two M8 lock washers (HP1-F). Tighten with a 1/2” wrench.

2.Thread M8 hex nut (HP1-H) onto the M8x80 hex cap screw (HP1-K) and install into the trunnion support as shown. Finger tighten the hex nut; this will be fully tightened later for the 90° table stop setting.

Installing Extension Table

Refer to Figure 22.

1.Install a M8 hex nut (HP2-C)on each of the four M8x20 set screws (HP2-D), then install these set screws into the four outer holes of the level board (G), as shown.

2.Leave the set screws flush with the top side of the level board for now. These will be adjusted later during leveling.

3.Place four spacers (HP2-B)over the holes in the saw body, and place the level board on them, as shown. Align the four innermost holes of the level board with the spacers, and insert four M8x65 socket head cap screws (HP2-H). Firmly tighten these screws down into the base through the spacers, using a 6mm hex wrench.

4.Position the extension table (K) over the level board. Insert four M6x25 socket head cap screws (HP2-E)with four M6 lock washers (HP2-F)and four M6 flat washers (HP2-G)up through the remaining holes of the plate and into the underside of extension table. Hand tighten only at this time.

Installing Main Table

Refer to Figure 23.

1.To mount the main table, remove table pin by pulling it straight out, twisting it if needed. Remove the table insert by pushing it up from beneath the table.

2.Rotate the table so that the saw blade will slide through the slot in the table. Then orient the table so the screws will slide into the holes on the trunnion support, as shown in Figure 23. Attach the two table locking knobs (HP1-E)to these screws and tighten.

3.Re-install table pin and table insert.

Figure 20

Figure 21

Figure 22