Sanyo 85464359981002 installation instructions Auto Address Setting Basic wiring diagram Example

8-4. Auto Address Setting

Basic wiring diagram: Example (1)

• If link wiring is not used

(The inter-unit control wires are not connected to multiple refrigerant systems.) Indoor unit addresses can be set without operating the compressors.

No. 1 unit settings

System address (system 1 setting)

(S003) (S002)

ON ON

1 2 OFF

No. of indoor units

(8 units setting)

(S004)

8

Outdoor Unit	Unit
	No. 1

Inter-unit control wiring

Indoor Unit	1-1	1-2	1-3	1-8
				Remote controller
Remote controller				cross-over wiring

Fig. 8-5

(1) Automatic Address Setting from the Outdoor Unit

1. On the outdoor unit control PCB, check that the system address rotary switch (S002) is set to “1” and that the

DIP switch (S003) is set to “0.” ON ON (These are the settings at the time of factory shipment.)

1 2 OFF

2.To set the number of indoor units that are connected to the outdoor unit to 8, on the outdoor unit control PCB set the No. of indoor units rotary switch (S004) to “8.”

3.Turn ON the power to the indoor and outdoor units.

4.On the outdoor unit control PCB, short-circuit the automatic address pin (CN51) for 1 second or longer, then release it.

(Communication for automatic address setting begins.)

↓* To cancel, again short-circuit the automatic address pin (CN51) for 1 second or longer, then pull it out. The LED that indicates that automatic address setting is in progress turns OFF and the process is stopped.

(Automatic address setting is completed when LEDs 1 and 2 on the outdoor unit control PCB turn OFF.)

↓

5.Operation from the remote controllers is now possible.

*To perform automatic address setting from the remote controller, perform steps 1 to 3, then use the remote controller and complete automatic address setting.

Refer to “Automatic Address Setting from the Remote Controller.”

72