Sanyo 85464359981002 Installing the Drain Piping, PVC pipe must be purchased separately

(2)The length of suspension bolts must be appropriate for a distance between the bottom of the bolt and the bottom of the unit of more than 19/32 in. as shown in Fig. 3-5.

(3)Thread the 3 hexagonal nuts and 2 washers (field

X	supply) onto each of the 4 suspension bolts as shown
	in Fig. 3-5. Use 1 nut and 1 washer for the upper side,

	Suspension bolt
Nuts and washers	Suspension lug
(use for upper and lower)

and 2 nuts and 1 washer for the lower side, so that the

Double nut

Notch

	unit will not fall off the suspension lugs.
(4)	Adjust so that the distance between the unit and the
	ceiling bottom is 15/32 to 43/64 in. Tighten the nuts on
	the upper side and lower side of the suspension lug.
(5)	Remove the protective polyethylene used to protect
	the fan parts during transport.

3-4. Installing the Drain Piping

(1) Prepare a standard hard PVC pipe (O.D. 1-1/4 in.) for

the drain and use the supplied drain hose and hose

band to prevent water leaks.

The PVC pipe must be purchased separately. The

15/32 – 43/64 (12 – 17)

Unit: in.

Fig. 3-5

			Hard PVC
	Hose band		socket	Hard PVC pipe
			VP-25
		Supplied		VP-25
Connection pipe
		drain hose	(Field supply)	(Field supply)
(drain port)

unit’s transparent drain port allows you to check

Align the hose

Packing

PVC adhesive

drainage. (Fig. 3-6)

CAUTION

●Insert the drain pipe until it contacts the socket, as shown in Fig. 3-6, then secure it tightly with the hose band.

●Do not use adhesive when connecting the supplied hose.

Reasons: 1. It may cause water to leak from the connection. Since the connection is slippery just after the adhesive has been applied, the pipe easily slips off.

2.The pipe cannot be removed when maintenance is needed.

●Do not bend the supplied drain hose 90° or more. The hose may slip off.

●Align the hose bands with the end of the hose. Tighten the hose band firmly. Please make sure that the bead is not covered by the hose band. (Fig. 3-6)

CAUTION	Tighten the hose clamps so
	their locking nuts face upward.
	(Fig. 3-6)

(2)After checking the drainage, wrap the supplied packing and drain pipe insulator around the pipe. (Fig. 3-7)

NOTE

Make sure the drain pipe has a downward gradient (1/100 or more) and that there are no water traps.

band with the end(supplied) of the pipe

Bead

Fig. 3-6

Drain insulator (supplied)

Fig. 3-7

Air bleeder prohibited

Fig. 3-8

CAUTION	● Do not install an air bleeder
	as this may cause water to
	spray from the drain pipe
	outlet. (Fig. 3-8)

26