Sega 4200-6367 owner manual Securing in Place Adjuster Adjustment, Bottom View, Casters, Adjusters

2

SECURING IN PLACE (ADJUSTER ADJUSTMENT)

Be sure to have all the Adjusters make contact with the surface. Un- less the Adjusters come into contact with the surface, the Cabinet can move of itself, causing an accident.

This machine has 8 each of casters and adjusters (shown below). When the installation position is determined, cause the adjusters to come into contact with the floor directly, make adjustments in a manner so that the casters will be raised approximately 5mm. from the floor and make sure that the machine position is level.

CASTERS

1Move the machine to the installation position.

2Cause all of the leg adjusters to make contact with the floor. By using a wrench, make adjustments in the height of the leg adjusters to ensure that the machine's position is level.

ADJUSTERS

3After making adjustments, fasten the leg adjuster nut upward and secure the height of the

leg adjuster. BOTTOM VIEW

4Depending on the floor surface status of the installation location, the Rear Cabinet may move of itself. As shown, the NON-SLIP SHEET is attached to the back side of the CAUTION MAT. Ensure that the Adjuster is installed in the manner to match the position of NON-SLIP SHEET

5After making adjustments, fasten the adjuster nut upwards and secure the height of the adjuster

11