11 . MONITOR
When performing such work as installing and removing the monitor, inserting and disconnect- ing the external connectors to and from monitor, be sure to disconnect the power connector (plug) before starting work. Proceeding the work without following this instruction can cause electric shock of malfunctioning.
Using the monitor by converting it without obtaining a prior permission is not allowed. SEGA shall not be liable for any malfunctioning and accident caused by said conversion.
Primary side and secondary side
The monitor’s circuit which is divided into the Primary side and secondary side, is electrically isolated. Do not touch the primary side and the secondary side simultaneously. Failing to observe the instruction can cause electric shock, and this is very dangerous. When making monitor adjustments, use a non- conductive driver and make adjustment without touching any other part other than the Adjustment V.R. and Knob. Also, be sure not to cause a short- circuit to the Primary side and the Secondary side. If
High tension Voltage
Some of the parts inside the monitor are subject to
Connecting the CRT and PCB
For combining the CRT and PCB, use the specified part No. to maintain the status of adjust- ments made at the factory. The anode of the CRT itself will be accumulitavly charged as time elapses, generating high tension voltage which is very dangerous. The monitor should be used with the Chassis, CRT and PCB assembled. When repair, etc. is required at the time of malfunc- tioning, be sure to send it in an “as assembled” condition. If these are dissassembled, what’s charged to said high tension voltage can be discharged, cuasing a very hazardous situation. Therefore, under no circumstances should it be dissasembled.
Static Electricity
Touching the CRT surface sometimes cuases you to slightly feel electricity. this is because the CRT surfaces are subject to static and will not adversly affect the human body.
Installation and removal
Ensure that the Magnetizer Coil, FBT
44