Touch Screen Calibration
Fig 4.2 Touch Screen Calibration Screen
Touch Screen Calibration – In the upper right corner of the calibration screen there is a box titled Touch Screen Calibration.
NOTE
This calibration is done at the factory and does not need to be done on a regular basis, only if the touch screen fails.
Select the box labeled Touch Screen Calibration. After a second, the touch target will move and a new screen will appear. In the center of the screen it will read Press the blinking X symbol until stop blinking.
•In the lower left corner of the screen a blinking X will appear and there will be a yellow to blue progress bar at the bottom of the screen.
•Hold your finger over the blinking X.
•When the X stops blinking, remove your finger and the X will move to the lower right hand corner.
Clarity User Guide, March 1, 2011 - Rev. 1.06 | Page 34 |