15
Adjusting the Volume/Screen Brightness
Basics
Adjusting the volume
1.Press the Volume/Screen Brightness Control in either direction to change the volume.
•Press plus (+) to increase the volume or minus
•When the system is in Sleep Mode, the volume can be decreased
but not increased. | Volume |
NOTE: The camera’s shutter sound will always play at a fixed volume, |
|
regardless of the current setting of the volume control. |
|
IMPORTANT: Under some conditions, noise from the Nintendo DSi XL speakers can cause audio feedback with the Nintendo DSi XL microphone. If you hear screeching, howling or other unexpected noise from the speakers, turn down the volume or use a set of stereo headphones.
How to start the system with low (muted) volume |
| + |
Turn the power on while holding down the |
| |
minus | Hold down | Turn power on |
Adjusting the screen brightness
1.Hold down SELECT.
2.Press the Volume/Screen Brightness Control in either direction to change the screen brightness.
Hold down
• Press plus (+) to increase the brightness | Screen Brightness | |
or minus | ||
|
NOTE: Changing the screen brightness will also change the brightness of the power indicator LED and the wireless indicator LED.
NOTE: Increasing the screen brightness will increase the power consumption. As a result, the power indicator LED may change from blue to red when the screen is made brighter. When this happens, note that the battery may run out and the system may lose power soon after the LED turns red.
The relationship between screen brightness and battery duration
16
Using SD Memory Cards
Basics
The Nintendo DSi XL supports
•Save photos you’ve taken in Nintendo DSi Camera to the SD Card
•Play
•Copy downloadable software and its save data to the SD Card
NOTE:
It may not be possible to copy some software.
Data copied to SD Cards cannot be used on other systems. Save data on Game Cards cannot be copied.
Song or sound files from the SD Card that have been manipulated are not saved.
IMPORTANT: An SD Card adapter is required to use miniSD or microSD Cards. When using a card adapter, be sure to remove the entire adapter (not just the card). Malfunction or damage to the system or your data could result if the card adapter is left in the system.
Inserting an SD Card
1. Open the SD Card slot cover.
Do not pull or twist the slot cover forcefully. Doing so could stretch or deform it, which could prevent the cover from closing correctly.
2.Insert the SD Card into the SD Card slot until it clicks into
place. Make sure the label side faces down.
Label faces down
Removing an SD Card
1.Open the SD Card slot cover and press on the end of the card until it clicks and partially ejects from the slot.
2. Grasp the SD Card and remove from the card slot.
IMPORTANT: Do not remove the SD Card while data is being read or written. This could damage the system or the SD Card, or destroy data.
Increasing the screen brightness will reduce the battery life. Decreasing the screen brightness will increase the battery life. Adjust the brightness based on your preference. See page 11 for more information.