Sega 999-0921 owner manual

1Turn the power off.

2Take out the 4 truss screws at the center of the steering wheel to remove the FRAME HORN BUTTON, CUSHION U and the CAP HORN BUTTON. A small part (called the PIN HORN BUTTON) is attached to the CAP HORN BUTTON. Be sure to keep it.

3Pull out the ROD HORN BUTTON.

4Remove the SPRING and the CUSHION L.

5Take out the hexagon nut.

6Remove the WASHER HANDLE SHAFT.

7Pull the STEERING HANDLE out of the HANDLE SHAFT. The HANDLE and the SHAFT are a nesting of the gear-shaped spline holes and the shaft. Be sure to pull the STEERING HANDLE vertically so as not to damage the shaft.

8Remove the COLLAR from the HANDLE SHAFT.

9Remove the 4 Tamperproof screws, and the 4 Phillips screws (8 total) on the angled metal plate located in front of and below the control panel. Remove the panel.

10Take out the 8 Tamperproof screws to remove the CONTROL PANEL . Use care so as not to damage the wiring inside the CONTROL PANEL COVER. .

11Disconnect the 2 connectors inside the CONTROL PANEL, and remove the CONTROL PANEL.

12Disconnect the HANDLE MECHA’s wire connectors (to the Horn and Start Button)