PROGRAMMING VCR/DVD PLAYER CONTROL
NOTE: If you own a TV/VCR combination, skip this section and perform “Programming TV/VCR Combo Control” on page 16.
Locate the brand name of your VCR in Setup Codes for VCRs on the next page, or your DVD player in Setup Codes for DVD Players on page 15, and write it in the appropriate space below.
VCR Brand: ________________________________
or
DVD Player Brand: ____________________________
The brands are listed in alphabetical order with the most popular codes listed first.You will use one of these codes to program the Millennium 4 to operate your VCR or DVD player:
1.Turn on your VCR and insert a video cassette, or turn on your DVD player and insert a DVD.
2. 
On the Millennium 4, press VCR once. Press and hold SETUP until the LED blinks twice, then release SETUP.
3.Enter the first
NOTE: If the LED did not blink twice after entering the code’s last digit, then repeat steps 2 through 3 and try entering the same code again.
4.Aim the Millennium 4 at the VCR or DVD player and press POWER once. The device
should turn off. If your VCR remote control does not have a POWER key, press PLAY. If the VCR does not respond, repeat steps 2 and 3, trying each code listed for your brand until you find one that works. If the device still does not work , try searching for the code (see Searching For Your Code on page 24).
5.For future reference, write your device’s code and type in the boxes and space below.
Device Type:________________________
NOTE: Remember, to use the Millennium 4 to operate your VCR or DVD player, press VCR first.
12