Universal Electronics 4 manual RE-ASSIGNING Device Keys, TV Audio

RE-ASSIGNING DEVICE KEYS

The Millennium 4 can be set up to control a second TV or VCR, or any combination of four home entertainment components. For example, to have the Millennium 4 control a TV, a Cable Converter, and two VCRs, you will need to re-assign the unused AUDIO key to operate the second VCR as follows:

1. On the Millennium 4, press and hold SETUP until the LED blinks twice, then release SETUP.

2. Enter 9 - 9 - 2. The LED will blink twice.

3. Press VCR once, then press AUDIO once.

4.The AUDIO key is now ready to be programmed for your second VCR. See Programming VCR/DVD Player Control on page 12.

To re-assign other device keys, repeat steps 1 through 4 by substituting the key sequence from the following chart for a desired component:

To Re-Assign	Perform Key Sequence
TV as 2nd VCR key:	SETUP - 9 - 9		- 2 - VCR - TV
TV as 2nd Audio key:	SETUP - 9 - 9		- 2 - AUDIO - TV
TV as 2nd Cable key:	SETUP - 9 - 9		- 2 - CBL - TV
TV back to TV:	SETUP - 9 - 9		- 2 - TV - TV
VCR as 2nd TV key:	SETUP - 9 - 9		- 2 - TV - VCR
VCR as 2nd Audio key:	SETUP - 9 - 9		- 2 - AUDIO - VCR
VCR as 2nd Cable key:	SETUP - 9 - 9		- 2 - CBL - VCR
VCR back to VCR:	SETUP - 9 - 9		- 2 - VCR - VCR
AUDIO as 2nd TV key:	SETUP - 9	- 9	- 2	- TV - AUDIO
AUDIO as 2nd VCR key: SETUP - 9		- 9	- 2	- VCR - AUDIO
AUDIO as 2nd Cable key: SETUP - 9		- 9	- 2	- CBL - AUDIO
AUDIO back to AUDIO:	SETUP - 9	- 9	- 2	- AUDIO - AUDIO

Upon completion of a re-assignment, the LED will blink twice to confirm your selection. At that time, you will also need to program the Millennium 4 to control the new component. See previous sections on Programming TV Control, Programming VCR/DVD Player Control, Programming Cable Converter (or DBS Receiver) Control, or Programming Audio Control.

26