Universal Electronics 4 manual Programming Audio Control, Setup Codes for Audio Amplifiers

PROGRAMMING AUDIO CONTROL

Locate the brand name of your audio amplifier or receiver in one of the accompanying code lists at the end of this section.Write it in the appropriate space below.

Audio Amplifier Brand: ________________________

or

Audio Receiver Brand:__________________________

The brands are listed in alphabetical order with popular codes listed first.You will use one of these codes to program the Millennium 4 to operate your audio device:

1.

2.

3.

Turn on the audio device.

On the Millennium 4, press AUDIO once. Press and hold SETUP until the LED blinks twice, then release SETUP.

Enter the first four-digit code for your audio device. If you perform this procedure correctly, the LED will blink twice.

NOTE: If the LED did not blink twice after entering the code’s last digit, then repeat steps 2 through 3 and try entering the same code again.

4.Aim the Millennium 4 at your audio device and press POWER once. The unit should turn off. If it does not respond, repeat steps 2 and 3, trying each code listed for your brand until you find one that works. If it still does not work , try searching for the code (see Searching For Your Code on page 24).

5.For future reference, write your device’s code and type in the boxes and space below.

NOTE: Remember, to use the Millennium 4 to operate your audio device, press AUDIO first.

Setup Codes for Audio Amplifiers:

Denon0160

GE0078

Harman/Kardon 0892

JVC0331

Marantz0892

22