(Continued)
To try to store a station name again, if the wrong name was stored in memory by mis- take:
When you store station names in memory using the ASPM function, the correct station names may not actually be stored if there is lots of noise or if the RDS station signal is too weak.
In this case, try storing station names in memory using the following procedure.
1,3
4,5 
2
2
4,5
Notes:
●When there are no station names stored in memory, you cannot use this function. In this case, when the STATION button is pressed, "NOTHING" will flash for 5 seconds, and the unit will return to the original display.
●This function can only be used when the FM band has been selected.
●The same station name can be stored in differ- ent preset channels. Therefore, when you are choosing a station name from the presets, the same station name may be encountered more than once.
●In a certain area or during certain time periods, the station names selected using the station se- lect function may temporarily be different from the name of the station you are actually receiv- ing.
1
2 Within 6 seconds, press the PRESET (X or W) button to check whether the station names are correct.
3 If you find a station name that is wrong, press the STATION button again within 6 seconds to recall the preset station, which corresponds to the station name.
4 After the preset station has been received and the correct station name has been displayed, press the MEMORY button.
5 Within 5 seconds, Press the MEMORY button again whilst the preset channel number is flash- ing.
●The new station name has been stored in memory correctly.
22