HP A7540-96010 manual Install SFP transceivers, Installing an SFP transceiver

Page 34

Installing

Install SFP transceivers

The switch has been validated with transceivers that support a variety of interconnection media. To install a transceiver, insert the transceiver into the port and gently push in on the SFP until the it snaps in place. To remove a transceiver, gently press the transceiver into the port to release the tension, and then pull out on the release tab to remove the transceiver from the chassis.

Note: The transceiver fits only one way in the port. If the transceiver does not install under gentle pressure, pull it out of the port, turn it over, and re-insert it.

Figure 13: Installing an SFP transceiver

34	HP StorageWorks 2/8q Fibre Channel Switch Installation Guide

Image 34

Contents HP StorageWorks 8q Fibre Channel Switch Copyright 2004 Hewlett-Packard Development Company, L.P Contents Troubleshooting Maintenance menu Remove Switch Config Figures Intended audience Related documentationText symbols Document conventionsEquipment symbols Rack stability HP installation and configuration assistanceGetting help HP storage web site HP technical supportHP authorized reseller About this Guide Switch chassis features Introduction1Serial port Power supplyInput Power LED green Chassis LEDsEthernet port System Fault LED solid amberHeartbeat LED green Placing the switch in maintenance mode Maintenance buttonResetting the switch Exiting maintenance modePort Logged-in LED green Fibre Channel ports and LEDsPort Activity LED green SFP transceivers Port typesCommand Line Interface Switch managementSwitch Manager user interface File Transfer ProtocolIntroduction Planning Device access DevicesHard zones Access Control Lists Soft zonesBandwidth PerformanceDistance LatencyUser account security Fabric securityFabric management Simple Network Management Protocol securityPlanning Installing Site requirementsInstalling and initially configuring the switch Unpack the switch and verify carton contentsMount the switch Using the rack templateAttaching the right rail to the rack rear view Attaching the mounting adapter brackets to the switch Placing the switch on the rails rear view Installing Install SFP transceivers Installing an SFP transceiverConnect power to the switch Connect Fibre Channel devices to the switchConnect the cables Installing Switch Manager on Windows systems Configure the switchInstalling Switch Manager on Linux systems Backing up the switch configuration Powering down the switchUsing Switch Manager to install firmware Updating switch firmwareUsing the CLI to install firmware Enter the password for your account name Installing Troubleshooting4 Post diagnostics Heartbeat LED blink patternsConfiguration file system error blink pattern System error blink patternInternal firmware failure blink pattern Over temperature blink pattern Logged-In LED indicationsPort Error blinking pattern Input Power LED is extinguished Chassis diagnosticsSystem Fault LED is illuminated Maintenance mode options Maintenance menu Image Unpack Maintenance menu ExitMaintenance menu Copy Log Files Maintenance menu Set Active Image Maintenance menu Remake FilesystemMaintenance menu Reset Switch Maintenance menu Update Boot LoaderTroubleshooting Class a equipment Federal Communications Commission NoticeClass B equipment Modifications CablesEuropean Union Notice Canadian Notice Avis CanadienBsmi Notice Japanese Notice Japanese Power Cord NoticeKorean notices Laser compliance Battery replacement notice Prevention methods Grounding methodsElectrostatic Discharge Specifications Fabric specificationsMaintainability Electrical DimensionsEnvironmental Regulatory certifications Management System Requirements Management system requirementsDirect Ethernet cross-over cable Cable pin configurationsIndirect Ethernet cable Serial cableEstablishing an Ethernet or serial connection Ethernet connection informationSerial connection information For Windows environmentsIndex Index Index Worldwide name Name server