HP A7340-96002 manual Setup, System Components

Page 19

2

SETUP

System Components

The HP Surestore FC 1Gb/2Gb Switch 16B consists of the following components:

A 1U chassis, designed to be mounted in a 19-inch rack, with forced-air cooling that flows from the power supply side of the switch to the SFP media side.

16 optical ports, compatible with SFPs (small form factor pluggable media).

One RS-232 serial port (DB9 connector) on the SFP media side.

One IEEE compliant RJ-45 connector on the SFP media side for use with 10/100 Mbps Ethernet or in-band.

A total of 36 LEDs:

Two LEDs for each of the 16 ports to indicate port status and link speed information.

One LED on each power supply to indicate the status of that power supply.

One LED on the left of the SFP media side to indicate whether the switch has power.

13

Image 19
Contents Quick start guide Hp surestore fc 1Gb/2Gb switch 16B Warranty Contents Specifications Revision History UpdatesRelated Publications Title Part Number Product Description Safety GuidelinesPackage Contents Installing the Switch as a Stand-Alone Unit FC 16B Rack-Mounted Switch Installing the Switch in a RackInstalling the Switch To install the switch in a rack Installing the Rear Rail-Tray Brackets Compaq/Rittal Rack Installing the Tinnerman Clips HP Rack Installing the Rubber Washers Assembling the Outer Rails HP Rack Installing Switch into an HP Rack Quick Start Guide System Components SetupSFP Media Side of the FC 16B SFP Media SidePower Supply Power Supply SideSFPs Fabric Operating SystemFibre Channel Cable Connections Description Configuring and Connecting the SwitchTo configure the FC 16B and connect it to a fabric Gateway Address 172.17.1.1 Enter the new gateway address Quick Start Guide Setup Backing up the Switch Configuration Settings Saving the System Configuration FilesRestoring the System Configuration Settings Setting Up Speed Negotiation Setting QuickLoop Mode on PortsNext Steps HP Surestore Director FC-64 Switch Configuring Supported DevicesHP Surestore VA Switch Status Indicators DiagnosticsLEDs on the SFP Media Side Diagnostics LEDs on the Power Supply Side Are faulty Maintenance and Diagnostic Tests Test Command Description Service and Support Additional Licenses Error MessagesGetting Support General SpecificationsEnvironmental Power Supply DimensionsQuick Start Guide Product Regulatory Information Germany Noise Declaration Laser Safety Declaration of Conformity Page Page Page A7340-96002