The following table describes the LEDs on each power supply. These LEDs indicate the status of the related power supply.
Color of LED | Status of Hardware | Recommended Action |
|
|
|
No light | Power supply is not providing |
| power. |
Verify power supply is on and power cable is connected to a valid power source.
Steady green | Power supply is providing | No action required. |
| power. |
|
|
|
|
The following table describes the LED in the center of the power supply side. This LED indicates the status of the switch.
Color of LED | Status of Hardware | Recommended Action |
|
|
|
No light | Either the switch is off, or boot |
| is not complete, or boot has |
| failed. |
Verify that the switch is on and boot has had time to complete. If there is still no light, contact HP support.
Steady green | Switch is on and boot has | No action required. |
| successfully completed. |
|
Steady yellow | Diagnostic command is in |
| progress, or one or more ports |
| are faulty. |
If no diagnostic tests are running, check the Port Status LEDs for fault indicators.
Diagnostic failure on one or | |
yellow | more ports. |
Errors may be listed in the error log. Refer to the Fabric OS Procedures Guide for more information.
Diagnostics | 31 |