HP A7340-96002 manual Diagnostics

Page 35

Color of LED

Status of Hardware

Recommended Action

 

 

 

Fast-flashing

The port is in internal loopback

No action required.

green (on 1/4

(diagnostic).

 

second; off 1/4

 

 

second)

 

 

 

 

 

Flickering green

Port is online, with traffic

No action required.

 

flowing through port.

 

 

 

 

Flashing or steady

POST is running.

No action required.

yellow

 

 

 

 

 

Steady orange

Port is receiving light or signal

No action required.

 

carrier, but is not yet online.

 

Slow-flashing

The port is disabled (result of

orange (on 1

diagnostics or portDisable

second; off 1

command).

second)

 

Reset the port from a management station.

Fast-flashing

The port is faulty.

Reset the switch from

orange (on 1/4

 

a management

second; off 1/4

 

station.

second)

 

 

 

 

 

Alternating green

Port is bypassed.

Reset the port from a

and yellow

 

management station.

 

 

 

The following table describes the LEDs above each port on the right. These LEDs indicate the speed of the port.

Color of LED

Status of Hardware

Recommended Action

 

 

 

No light

The port is

No action required.

 

transmitting/receiving at 1

 

 

Gbps.

 

 

 

 

Steady green

The port is

No action required.

 

transmitting/receiving at 2

 

 

Gbps.

 

 

 

 

Diagnostics

29

Image 35
Contents Quick start guide Hp surestore fc 1Gb/2Gb switch 16B Warranty Contents Specifications Related Publications UpdatesRevision History Title Part Number Product Description Safety GuidelinesPackage Contents Installing the Switch as a Stand-Alone Unit FC 16B Rack-Mounted Switch Installing the Switch in a RackInstalling the Switch To install the switch in a rack Installing the Rear Rail-Tray Brackets Compaq/Rittal Rack Installing the Tinnerman Clips HP Rack Installing the Rubber Washers Assembling the Outer Rails HP Rack Installing Switch into an HP Rack Quick Start Guide System Components SetupSFP Media Side of the FC 16B SFP Media SidePower Supply Power Supply SideFibre Channel Cable Connections Fabric Operating SystemSFPs Description Configuring and Connecting the SwitchTo configure the FC 16B and connect it to a fabric Gateway Address 172.17.1.1 Enter the new gateway address Quick Start Guide Setup Backing up the Switch Configuration Settings Saving the System Configuration FilesRestoring the System Configuration Settings Next Steps Setting QuickLoop Mode on PortsSetting Up Speed Negotiation HP Surestore Director FC-64 Switch Configuring Supported DevicesHP Surestore VA Switch Status Indicators DiagnosticsLEDs on the SFP Media Side Diagnostics LEDs on the Power Supply Side Are faulty Maintenance and Diagnostic Tests Test Command Description Getting Support Error MessagesService and Support Additional Licenses General SpecificationsEnvironmental Power Supply DimensionsQuick Start Guide Product Regulatory Information Germany Noise Declaration Laser Safety Declaration of Conformity Page Page Page A7340-96002